1. DL manuals
  2. EarthQuake
  3. Tiller
  4. 5055C
  5. Operator's Manual

EarthQuake 5055C Operator's Manual

Summary of 5055C

  • Page 1

    Getearthquake.Com crt rototillers operators manual omcrt rev. 10/06/10 © 2010 ardisam, inc. All rights reserved. 5055c briggs & stratton 4-cycle 206cc 8.50 ft-lbs gross torque 6065vec viper electric 4-cycle, 196 cc.

  • Page 2

    Operator instructions and parts crt models 5055c & 6065vec page 2 getearthquake.Com 800-345-6007 introduction thank you . . . For purchasing an earthquake® counter rotating rear-tine rototiller from ardisam, inc. We have worked to ensure that this rear-tine rototiller meets high standards for usabil...

  • Page 3

    Operator instructions and parts crt models 5055c & 6065vec page 3 getearthquake.Com 800-345-6007 safety owner’s responsibility accurate assembly and safe and effective use of the rototiller is the owner’s responsibility. • read and follow all safety instructions. • carefully follow all assembly inst...

  • Page 4

    Operator instructions and parts crt models 5055c & 6065vec page 4 getearthquake.Com 800-345-6007 important the right and left sides of your rototiller are deter- mined from the operating posi- tion as you face the direction of forward travel. Engine is shipped from factory without oil. You must add ...

  • Page 5

    Operator instructions and parts crt models 5055c & 6065vec page 5 getearthquake.Com 800-345-6007 part no. Lbl516aa warning instructions hood decal part no. Lbl516c warning belt cover decal part no. Lbl516j tines danger hood flap decal safety decals this rototiller unit has been designed and manufact...

  • Page 6: Important

    Operator instructions and parts crt models 5055c & 6065vec page 6 getearthquake.Com 800-345-6007 unpacking and assembly your rototiller comes fully assembled except for a few parts. The fol- lowing instructions will help you unpack your tiller and assemble and adjust your tiller’s depth regulator le...

  • Page 7

    Operator instructions and parts crt models 5055c & 6065vec page 7 getearthquake.Com 800-345-6007 features forward drive safety control lever detent pin forward & reverse cable recoil start serial number plate wheel lock pin belt guard reverse drive safety control lever depth regulator lever bumper g...

  • Page 8: Danger

    Operator instructions and parts crt models 5055c & 6065vec page 8 getearthquake.Com 800-345-6007 operation pre-start inspection 1. Make sure all safety guards are in place and all nuts and bolts are secure. 2. Check oil level in engine crankcase. See your engine manual for procedure and specificatio...

  • Page 9

    Operator instructions and parts crt models 5055c & 6065vec page 9 getearthquake.Com 800-345-6007 idle speed use the “low” position on the throttle lever to reduce stress on the engine when tilling is not being performed. Lowering the engine speed to “idle” will help extend the life of the motor, as ...

  • Page 10

    Operator instructions and parts crt models 5055c & 6065vec page 10 getearthquake.Com 800-345-6007 drive safety control levers forward lever engages wheels and tines into forward. Pulling the drive safety control lever labeled (forward) toward the handlebar engages the wheels and tines. Releasing the...

  • Page 11

    Operator instructions and parts crt models 5055c & 6065vec page 11 getearthquake.Com 800-345-6007 wheel lock pins place wheels in tilling position. 1. Remove lock pin. Align hole in axle with hole in wheel hub. (see figure 2) 2. Insert lock pin through holes, fold lock pin ring to secure pin to axle...

  • Page 12

    Operator instructions and parts crt models 5055c & 6065vec page 12 getearthquake.Com 800-345-6007 depth regulator lever tilling depth is controlled by the height of the depth regulator lever. To adjust tilling depth. (see figure 4) 1. Remove detent pin. 2. Raise the depth regulator lever to position...

  • Page 13

    Operator instructions and parts crt models 5055c & 6065vec page 13 getearthquake.Com 800-345-6007 tilling tips the key to successful tilling is to begin with a shallow cut on the first pass, and then work an inch or two deeper on each successive pass. • tilling depth will vary with ground conditions...

  • Page 14

    Operator instructions and parts crt models 5055c & 6065vec page 14 getearthquake.Com 800-345-6007 servicing the rototiller the following information will help you make the necessary checks and perform the procedures required to follow the normal care recommendations made for your rototiller unit. If...

  • Page 15

    Operator instructions and parts crt models 5055c & 6065vec page 15 getearthquake.Com 800-345-6007 belt replacement part #’s: 727a (forward) 730 (reverse) change forward/reverse belt 1. Turn off engine. Engine must be cool. 2. Remove spark plug wire and secure from spark plug. 3. Remove belt guard. •...

  • Page 16: Important

    Operator instructions and parts crt models 5055c & 6065vec page 16 getearthquake.Com 800-345-6007 engine maintenance refer to the engine manual included in your parts packet for information on engine maintenance. Your engine manual provides detailed information and a maintenance schedule for perform...

  • Page 17

    Operator instructions and parts crt models 5055c & 6065vec page 17 getearthquake.Com 800-345-6007 lubrication proper lubrication of moving mechanical parts is critical for proper care and maintenance. Oil the moving parts at 10 hour intervals using a 30 weight oil. Clean tine axle shaft 1. Turn off ...

  • Page 18

    Operator instructions and parts crt models 5055c & 6065vec page 18 getearthquake.Com 800-345-6007 troubleshooting troubleshooting guide while normal care and routine maintenance will extend the life of your rototiller, prolonged or constant use may eventually re- quire that service be performed to a...

  • Page 19

    Operator instructions and parts crt models 5055c & 6065vec page 19 getearthquake.Com 800-345-6007 problem remedy/action belts squeal in neutral and/or reverse • adjust forward belt guide: - turn engine off and allow muffler to cool - disconnect spark plug wire and secure from spark plug - remove bel...

  • Page 20

    Operator instructions and parts crt models 5055c & 6065vec page 20 getearthquake.Com 800-345-6007 crt handlebar parts 16 8 7 6 10 4 5 3 12 18 13 11 1 2 15 14 17 19 20 9 1 14 19.

  • Page 21

    Operator instructions and parts crt models 5055c & 6065vec page 21 getearthquake.Com 800-345-6007 crt handlebar parts list ref. No. Part # description qty. 1 2104 nut hex two-way 3/8-16 6 2 48762 bolt 3/8-16 x 1” carriage 2 3 503 bolt 5/16-24x1” hh gr5 1 4 53606 nut-nyloc, #10 2 5 53607 nut-jam, 5/1...

  • Page 22

    Operator instructions and parts crt models 5055c & 6065vec page 22 getearthquake.Com 800-345-6007 crt motor mount parts 10 6 14 32 9 33 28 30 24 31 26, 27 23 33 7 18 23 17 19 5 7 2 33 25 20 8 13 33 29 9 1 6 15 33 12 16 33 9 32 23 22, 21 8 3 11 4 25 2 7 33 34 33 6.

  • Page 23

    Operator instructions and parts crt models 5055c & 6065vec page 23 getearthquake.Com 800-345-6007 crt motor mount parts list r e f . No. Part # description qty. 1 1407 forward arm spring 2 2 1408 forward pulley idler 2 3 1416 clevis pin 1 4 1418 cotter pin 5/64” x 1/2” 1 5 1423 bolt 5/16-18 x 2” 4 6...

  • Page 24

    Operator instructions and parts crt models 5055c & 6065vec page 24 getearthquake.Com 800-345-6007 crt tines & hood parts 11 2 22 5 8 9 17 20 10 28 31 30 18 29 26 27 16 19 3 24 21 3 7 6 5 14 12 25 15 1 3 18 16 4 22 13 23 18.

  • Page 25

    Operator instructions and parts crt models 5055c & 6065vec page 25 getearthquake.Com 800-345-6007 crt tines & hood parts list ref. No. Part # description qty. 1 1103 lock pin 5/16” x 1-3/4” 2 2 1500crt5 transmission assembly, lock pin 1 3 1501 bolt 5/16-18 x 3/4” 7 4 1504 gasket, transmission 2 5 15...

  • Page 26

    Operator instructions and parts crt models 5055c & 6065vec page 26 getearthquake.Com 800-345-6007 crt wheel & tiller shaft parts & parts list ref. No. Part # description qty. 1 1500p101 bolt, m6 x 25mm 6 2 1500p102 cover, rear transmission 1 3 1500p103 gasket, front and rear transmission cover 2 4 1...

  • Page 27: Crt Rototillers

    Crt rototillers 1-year limited warranty terms and conditions ardisam, inc., a manufacturing company, warrants this earthquake® crt rototiller to be free from defects in the material or workmanship for a period of one year from the date of purchase. During the one-year warranty of this product, ardis...

  • Page 28

    Earthquake, division of ardisam, inc. 1160 eighth avenue; p.O. Box 666 cumberland, wisconsin 54829 800-345-6007 · fax (715) 822-2223 e-mail: info@ardisam.Com getearthquake.Com visit www.Ardisam.Com and discover more innovations that will benefit you throughout the year..