1. DL manuals
  2. EarthQuake
  3. Tiller
  4. 6014V CRT
  5. Operator Instructions And Parts

EarthQuake 6014V CRT Operator Instructions And Parts

Other manuals for 6014V CRT: Operator Instructions And Parts
Manual is about: CRT ROTOTILLER

Summary of 6014V CRT

  • Page 1

    Ardisam .Com getearthquake.Com 6014v crt rototiller operator’s manual om6014 rev. 7/13/09 © 2009 ardisam, inc. All rights reserved. Printed in usa. 6014v viper engine 196 cc.

  • Page 2

    Operator instructions and parts crt models 6014v page getearthquake.Com 800-345-6007 introduction thank you . . . For purchasing an earthquake® counter rotating rear-tine rototiller from ardisam, inc. We have worked to ensure that this rear-tine rototiller meets high standards for usability and dura...

  • Page 3

    Operator instructions and parts crt models 6014v page 3 getearthquake.Com 800-345-6007 safety owner’s responsibility accurate assembly and safe and effective use of the rototiller is the owner’s responsibility. • read and follow all safety instructions. • carefully follow all assembly instructions. ...

  • Page 4

    Operator instructions and parts crt models 6014v page 4 getearthquake.Com 800-345-6007 important the right and left sides of your rototiller are deter- mined from the operating posi- tion as you face the direction of forward travel. Engine is shipped from factory without oil. You must add en- gine o...

  • Page 5

    Operator instructions and parts crt models 6014v page 5 getearthquake.Com 800-345-6007 part no. Lbl516aa warning instructions hood decal part no. Lbl516c warning belt cover decal part no. Lbl516j tines danger hood flap decal safety decals this rototiller unit has been designed and manufactured to pr...

  • Page 6: Important

    Operator instructions and parts crt models 6014v page 6 getearthquake.Com 800-345-6007 unpacking and assembly your rototiller comes fully assembled except for a few parts. The fol- lowing instructions will help you unpack your tiller and assemble and adjust your tiller’s depth regulator lever, cable...

  • Page 7

    Operator instructions and parts crt models 6014v page 7 getearthquake.Com 800-345-6007 features forward drive safety control lever detent pin forward cable recoil start wheel lock pin belt guard depth regulator lever.

  • Page 8: Danger

    Operator instructions and parts crt models 6014v page 8 getearthquake.Com 800-345-6007 operation pre-start inspection 1. Make sure all safety guards are in place and all nuts and bolts are secure. 2. Check oil level in engine crankcase. See your engine manual for procedure and specifications. 3. Ins...

  • Page 9

    Operator instructions and parts crt models 6014v page getearthquake.Com 800-345-6007 idle speed use the “low” position on the throttle lever to reduce stress on the engine when tilling is not being performed. Lowering the engine speed to “idle” will help extend the life of the motor, as well as cons...

  • Page 10

    Operator instructions and parts crt models 6014v page 10 getearthquake.Com 800-345-6007 drive safety control lever forward lever engages wheels and tines into forward. Pulling the drive safety control lever toward the handlebar engages the wheels and tines. Releasing the lever stops the wheels and t...

  • Page 11

    Operator instructions and parts crt models 6014v page 11 getearthquake.Com 800-345-6007 wheel lock pins place wheels in tilling position. 1. Remove lock pin. Align hole in axle with hole in wheel hub. (see figure ) 2. Insert lock pin through holes, fold lock pin ring to secure pin to axle. 3. Firmly...

  • Page 12

    Operator instructions and parts crt models 6014v page 1 getearthquake.Com 800-345-6007 depth regulator lever tilling depth is controlled by the height of the depth regulator lever. To adjust tilling depth. (see figure 4) 1. Remove detent pin. 2. Raise the depth regulator lever to position tines at c...

  • Page 13

    Operator instructions and parts crt models 6014v page 13 getearthquake.Com 800-345-6007 tilling tips the key to successful tilling is to begin with a shallow cut on the first pass, and then work an inch or two deeper on each successive pass. • tilling depth will vary with ground conditions. • when b...

  • Page 14

    Operator instructions and parts crt models 6014v page 14 getearthquake.Com 800-345-6007 servicing the rototiller the following information will help you make the necessary checks and perform the procedures required to follow the normal care recommendations made for your rototiller unit. If you prefe...

  • Page 15: Figure 6

    Operator instructions and parts crt models 6014v page 15 getearthquake.Com 800-345-6007 belt replacement part #’s: 31315 (forward belt) change forward/reverse belt 1. Turn off engine. Engine must be cool. 2. Remove spark plug wire and secure from spark plug. 3. Remove belt guard. (see figure 6) • re...

  • Page 16: Important

    Operator instructions and parts crt models 6014v page 16 getearthquake.Com 800-345-6007 engine maintenance refer to the engine manual included in your parts packet for information on engine maintenance. Your engine manual provides detailed information and a maintenance schedule for performing the fo...

  • Page 17

    Operator instructions and parts crt models 6014v page 17 getearthquake.Com 800-345-6007 lubrication proper lubrication of moving mechanical parts is critical for proper care and maintenance. Oil the moving parts at 10 hour intervals using a 30 weight oil. Clean tine axle shaft 1. Turn off engine. En...

  • Page 18

    Operator instructions and parts crt models 6014v page 18 getearthquake.Com 800-345-6007 troubleshooting troubleshooting guide while normal care and routine maintenance will extend the life of your rototiller, prolonged or constant use may eventually require that service be performed to allow it to c...

  • Page 19

    Operator instructions and parts crt models 6014v page 1 getearthquake.Com 800-345-6007 problem remedy/action belts squeal in neutral • adjust forward belt guide: - turn engine off and allow muffler to cool - disconnect spark plug wire and secure from spark plug - remove belt guard - pull down on dri...

  • Page 20

    Operator instructions and parts crt models 6014v page 0 getearthquake.Com 800-345-6007 crt handlebar parts 2 3 1 4 10 8 7 6 5.

  • Page 21

    Operator instructions and parts crt models 6014v page 1 getearthquake.Com 800-345-6007 crt handlebar parts list ref. No. Part # description qty. 1 3262 deadman, front tine weldment 1 2 53613 link, 9-1/2” long 1 3 53606 nut, 10-24 hex zn 1 4 53620 spring compression forward arm rt 1 5 53607 nut, 5/16...

  • Page 22

    Operator instructions and parts crt models 6014v page getearthquake.Com 800-345-6007 crt motor mount parts 1 2 3 4 5 6 7 8 9 11 13 15 10 12 14a 16 17 18 19 20 21 22 23 24 25 26 27 28 30 29 31 32 34 36 33 35 37 38 3 1 2 3 21 19 3 19 17 15 14b 2 3.

  • Page 23

    Operator instructions and parts crt models 6014v page 3 getearthquake.Com 800-345-6007 crt motor mount parts list ref. No. Part # description qty. 1 810 bolt, 5/16-24 x 1 hh gr5 2 2 504 lockwasher, r-spring 5/16” 9 3 wf516 washer, flat 5/16” standard zn 12 4 53649 guard, belt rear tine 12/05 1 5 536...

  • Page 24

    Operator instructions and parts crt models 6014v page 4 getearthquake.Com 800-345-6007 crt tines & hood parts 1 1 2 2 3 4 5 6 7a 8 9 10 15 16 17 14 13 12 11 18 4 8 4 7a 11 7b 2.

  • Page 25

    Operator instructions and parts crt models 6014v page 5 getearthquake.Com 800-345-6007 crt tines & hood parts list ref. No. Part # description qty. 1 417 bolt, 5/16-18 x 1/2 hh gr5 4 2 504 lockwasher, spring 5/16” 9 3 31311 hood, assembly tine w/hinge narrow 1 4 1501 bolt, 5/16-18 x 3/4 hh gr5 zn 13...

  • Page 26

    Operator instructions and parts crt models 6014v page 6 getearthquake.Com 800-345-6007 crt wheel & tiller shaft parts & parts list ref. No. Part # description qty. 1 1500p101 bolt, m6 x 25mm 6 2 1500p102 cover, rear transmission 1 3 1500p103 gasket, front & rear transmission cover 2 4 1500p104 shim,...

  • Page 27: 6014V Crt Rototiller

    6014v crt rototiller 1-year limited warranty terms and conditions ardisam, inc., a manufacturing company, warrants this earthquake® crt rototiller to be free from defects in the material or workmanship for a period of one year from the date of purchase. During the one year warranty of this product, ...

  • Page 28

    Earthquake, division of ardisam, inc. 1360 first avenue; p.O. Box 666 cumberland, wisconsin 54829 800-345-6007 · fax (715) 822-2223 e-mail: info@ardisam.Com getearthquake.Com visit www.Ardisam.Com and discover more innovations that will benefit you throughout the year..