EarthQuake BP112 Owner's Manual

Other manuals for BP112: Brochure, Owner's Manual
Manual is about: Earthquake DB-10: Product Brochure

Summary of BP112

  • Page 1

    Earthquake sound reserves the right to amend details of the specifications without notice. Copyright © earthquake sound corporation earthquake sound corporation • 2727 mccone avenue hayward ca, 94545 • phone: 510- 732-1000 fax: 510-732-1095 the sound that will move you. Sound that will move you. 12"...

  • Page 2

    Five (5) year limited warranty: earthquake warrants the original purchaser that all factory sealed new audio products be free from defects in material and workmanship under normal and proper use for a period of five (5) years from the date of purchase (as shown on the original bill of sale with seri...

  • Page 3

    Warranty claim will not be valid if the warranty registration card is not properly filled out & returned to earthquake with a copy of the sales invoice. A (e) service request: to receive product/s service, contact earthquake's service department at (510) 732-1000 and request an rma number (return ma...

  • Page 4

    6 7 power supply connections positive: connect a wire (at least 12-gauge) between the vehicles +(positive) battery terminal and the "+12v" connection on bp112 amplifier. You must install a fuse holder with a 50-75a fuse, within 18" of the battery. Route the power wire through a grommet in the vehicl...

  • Page 5

    Www.Earthquakesound.Com specifications are subject to change without notice phase control: the phase control is a switch located on the panel with the electrical connections. This switch will reverse the phase of bp112's output with respect to its input. When installing bp112 with an existing factor...

  • Page 6

    1. Start with gain control set to minimum and the crossover control and bass control rotated midway, to 12 o’clock. 2. Choose program material with substantial bass content and turn the volume control on your head unit to three-quarters of its total output (approximately 3 o’clock on rotary controls...