EarthQuake Nova PA-600 Operation manual Technical Manual

Summary of Nova PA-600 Operation manual

  • Page 1

    Nova power from the heavens pa-600 professional amplifier operation manual & technical guide earthquake sound corporation. 2727 mc cone avenue, hayward, ca 94545. Www.Earthquakesound.Com. Power protect peak signal ch 1 level min max mono ch 2 level signal peak protect min max ch 2 ch 1 speaker outpu...

  • Page 3

    Earthquake sound corporation specializes in manufacturing high end home and car audio products ranging from the smallest driver to the loudest subwoofer system. In its dedication to excellence, earthquake has maintained extensive programs in research and development to provide you with the highest q...

  • Page 4

    Power protect peak signal ch 1 level min max mono ch 2 level signal peak protect min max specifications & features are subject to change without notice. Www.Earthquakesound.Com pa-600 amplifier front & rear panels functions/connection. 5 6 4 2 3 1 6 5 7 10 14 14 15 8 11 11 12 12 13 13 16 17 18 7 1. ...

  • Page 5

    Pa-600 amplifier front & rear panels functions/connection. These jacks accept line level signal sources by means of cables fitted with standard ¼” phone 6. Signal indicator leds: plugs. Low or medium impedance balanced or unbalanced sources are acceptable for these these led's illuminate when signal...

  • Page 6

    Pa-600 amplifier connection (stereo & mono) from audio source from audio source from audio source 2 to 8 ohms range note: use both red terminals only in mono mode 2 to 8 ohms range 4 to 8 ohms range the pa-600 can be used in stereo mode as two separate power amplifiers, each capable of driving loads...

  • Page 7

    Pa-600 amplifier operation stereo mode: bridge mono mode: the following diagrams are excerpts from the system block diagrams and are intended to provide a simplified view of the operating modes of the amplifier. Bridge mono switch: this switch connects the channels to work together for more power ou...

  • Page 8

    17.06" 433.3mm 19.00" 482.6mm 3 .4 9 " 8 8 .8 m m 1 .8 5 " 4 6 .9 m m indicates center of gravity 1.54" 39.1mm 15.43" 392mm pa-600 amplifier installation & mounting the pa-600 is specifically designed to be rack mounted, either as a permanent fixture or in a "mobile" rack. As with any large, heavy o...

  • Page 9

    Power output frequency response total harmonic distortion slew rate signal to noise ratio load impedance damping factor controls input connections output connections mode switches protection circuitry cooling power requirements size and weight 2 x 120 watts rms @ 8 ohms 20hz-20khz (stereo mode) 2 x ...

  • Page 10

    Earthquake warrants the original purchaser that all factory sealed new audio - subsequent damage to other products. Products be free from defects in material and workmanship, under normal and proper use, a warranty claim will not be valid if the warranty registration card is not properly filled & fo...

  • Page 11

    Warranty registration card cut along dotted line & return to earthquake sound corporation. 2727 mc cone a venue, hayward , ca 94545. Required information: first name:___________________________________________________________________________ last name:________________________________________________...

  • Page 12

    To: earthquake sound corporation. 2727 mc cone a venue, hayward, california 94545. Ph (510) 732-1000. Place stamp here f rom: _______________________ ____________________________ ____________________________ ____________________________ limited 5 years warranty (v alid in u.S. Mainland only- excludi...