1. DL manuals
  2. EarthQuake
  3. Amplifier
  4. PH10000W/D1
  5. Owner's Manual

EarthQuake PH10000W/D1 Owner's Manual

Other manuals for PH10000W/D1: Brochure, Owner's Manual, Owner's Manual
Manual is about: PowerHouse Series Amplifiers

Summary of PH10000W/D1

  • Page 1

    Earthquake sound reserves the right to amend details of the specifications without notice. Copyright © earthquake sound corporation earthquake sound corporation • 2727 mccone avenue hayward ca, 94545 • phone: 510- 732-1000 fax: 510-732-1095 the sound that will move you. Earthquake sound models: ph80...

  • Page 2

    Warranty continued on next page 2 3 earthquake amplifiers are capable of generating high sound pressure levels. You should exercise caution when operating these amplifier systems. Long term exposures to high levels of sound pressure will cause permanent damage to your hearing. Sound pressure levels ...

  • Page 3

    4 specifications are subject to change without notice 5 please keep this warranty information in your files for future reference if necessary. It is recommended that you stick your serial number here for future reference. Serial number specifica tions model channels ph800w/2 ph1000w/2 ph2200w/4 ph20...

  • Page 4

    6 7 ph800w/2 rem power born in the usa fuse ch2 gnd bat ch1 mono speaker output bypass 2 gain power rca level input speaker level input 1 2 1 1- 1+ 2- 2+ bypass protect 20hz filter setting crossover frequency 5khz crossed rca level outputs, can be used to feed other amplifiers in the system. To car ...

  • Page 5

    Ph1000w/2 30a fuse s p e a k e r o u t p u t s minimum 4 ohm mono the gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (please refer to t...

  • Page 6

    Ph2200w/4 10 11 signal sensor: remote on/auto on feature (see page 5). Two 30a fuses speaker outputs minimum 4 ohm mono the gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp...

  • Page 7

    Ph2000w/ 1 d 12 13 variable 10db boost at 40hz. Perfect tool for high spl scores. Full time low-pass variable filter 12db/oct slope, range from 50 to 300hz through output feeds other amplifiers in the audio system. Not effected by the low- pass filter. The gain knob is not a volume control. It is de...

  • Page 8

    Ph5000w/ 1 d rem gnd bat the gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (please refer to table for settings). • test the alternator...

  • Page 9

    Ph10000w/ 1 d the gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (please refer to table for settings). Do not solder the tip of the pow...

  • Page 10

    2 ohms minimum 10000 watts rated output master amplifier audio signal slave amplifier phase shift 0 180 phase shift 0 180 head unit / audio source rem gnd ba t rem gnd ba t • set master amp to 0 • set slave amp phase to 180 • set gains equal on both master & slave amplifiers • set th bass boosts and...