Earthquake sound reserves the right to amend details of the specifications without notice. Copyright © earthquake sound corporation earthquake sound corporation • 2727 mccone avenue hayward ca, 94545 • tel 510-732-1000 tnt series amplifiers owners manual t500w/2 t1000w/2 t2000w/4 t2000wd/1 td5x mode...
Our thank you................................................................................ Cautions and advisories................................................................. Signal sensing feature.................................................................. Specifications.................
4 5 specifications model t500w/2 t1000w/2 t2000w/4 t2000wd/1 td5x class a/b a/b a/b d d number of channels 2 2 4 1 mono 4 full range + 1 mono max power output 800 watts 1400 watts 2000 watts 2000 watts 3000 watts max power 4-ohm bridged 1 x 400 1 x 700 2 x 250 1 x 1000 @ 2 Ω 2 x 100 @ 4 Ω + 1 x 300 ...
6 7 t500w/2 set xover switch to full k-10, ten-inch bass tube, in mono application (4 ohms minimum) 7.0v 17.0v 4.0v 10.0v 2.5v 5.0v 1v 1v the gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving "clipping" the inpu...
8 9 t1000w/2 set xover switch to full k-10, ten-inch bass tube, in mono application (4 ohms minimum) two 25a fuses to car chassis / ground to remote turn on / trigger to battery positive (+) bridgeable speaker outputs, minimum 4-ohms mono. 7.0v 17.0v 4.0v 10.0v 2.5v 5.0v 1v 1v the gain knob is not a...
10 11 t2000w/4 bridgeable speaker outputs, minimum 4-ohms mono. Set xover switch to full k-10, ten-inch bass tube, in mono application (4 ohms minimum) ch3 ch4 ch3 ch4 ch1 ch2 ch1 ch2 to car chassis / ground to remote turn on / trigger to battery positive (+) two 20a fuses 7.0v 17.0v 4.0v 10.0v 2.5v...
12 13 t2000wd/1 subsonic filter: for the vast majority of vehicles, peaks or dips occur at about 40hz – around the frequency of a low bass guitar note. Use this control to correct that peak or dip. Phase shift: this 0 - 180° phase shift adjustment is for reversing the phase output with respect to it...
Output ch2+ ch2- ch2+ ch4+ ch5- ch2- ch4- ch5+ ch2- ch4- front bridged bridged ch1- ch1+ ch1- ch3- ch1+ ch3+ ch1+ ch3+ sub - + ch4+ ch4- rear ch3- ch3+ fc6.2 mid-range fc6.2 xover fc6.2 xover fc6.2 tweeter fc6.2 tweeter fc6.2 mid-range focus eq-693 focus eq-693 the sub channel will accept 2 or 4-ohm...
