EarthQuake Titan Theia Manual - page 6
ver since the release of the Telesto and Tigris,
E
many of you inquired us to produce a center
channel to match those Titan towers. To be honest,
we were already in the process of developing the
product then. However, as an avid audiophile, I could
not let the product make its way to the sales floor
without sweating the details from all possible angles.
Many of you have provided us with design
requirements, development ideas and tremendous
feedback that helped us improved our products. We
are truly grateful for all your support and feedback.
From all of us at Earthquake Sound Corporation:
Thank you & enjoy.
Well, the wait is finally over.
After years in development, I proudly present to you
the Theia center channel speaker, part of the Titan
Series.
Introduction
arthquake Sound presents its next creation from
the TITAN series, the Theia center channel
E
speaker.
Its sleek exterior is matched only by its performance.
Theia’s curved cabinet design integrates the Acoustic
Array System Design (AASD) technology to allow
The patented Piston-Max Technology (PMT) is
even audio distribution in a wider listening area.
integrated into Theia’s four 4” Kevlar cones to
increase efficiency and accuracy of music
reproduction. The motor and voice coil structures of
these drivers are fully isolated, allowing them to
operate with extremely low distortion. In addition,
each Theia driver is magnetically shielded to prevent
interference from any nearby components (TV,
receiver, Blu-ray players, etc.).
Theia also incorporates the patented Symmetrically
Loaded Audio Passive System (SLAPS) which
dramatically increases its efficiency as well as
extends its sub-harmonic frequency response.
With two 1” (25mm) silk dome tweeters positioned at
the very front and center of the unit, Theia can
achieve perfect positioning for wider dispersion and
better image stability, allowing everyone in the room
can equally enjoy Theia’s superior performance.
Theia Design
6 Theia Manual
Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
Joseph J. Sahyoun
President & Chief Engineer
Figure 1.
Theia’s Acoustic Array System Design (AASD)
audio dispersion.
Figure 2.
SLAPS (Symmetrically Loaded Audio Passive
Systems)
Tweeter Sound Wave
Driver Sound Wave