EarthQuake VECTOR Operator's Manual - Important
Check for parts online at
www.getearthquake.com or call 800-345-6007 M-F 8-5
9
Operator's Manual
VECTOR™ Compact Tiller
UNPaCkING aND aSSEmBlY
UNPaCkING aND aSSEmBlING YOUR TIllER
1. Open top of carton and remove handlebar assembly.
2. Parts bag for Vector tiller contains:
8- Bolts M8 x 1.25 x 25 Hex Head
6- Washers M8 8.4mm x 24mm x 2.2mm
6- Nuts M8 x 1.25
2- Middle Handlebar Straps
2- Hand Knobs
6- Bolts M6 x 1.0 x 12
6- Nylock Nuts M6 x 1.0
3. Remove machine from carton
4. Assemble the upper handlebar onto the lower handlebar loop.
Use the two (2) middle handlebar straps to connect the up-
per handlebar to the lower handlebar loop. Put the M8 bolts
through bolt holes from the outside in. Put on six (6) wash-
ers and tighten with six (6) M8 nuts on the six (6) lower bolts.
Tighten the two (2) M8 hand knobs on the two (2) upper most
bolts on each side of the handlebar. SEE FIGURES 1 aND 2.
The two (2) upper bolts and hand knobs can be used in one
of three hole positions for handlebar height adjustability. SEE
FIGURE 3.
Figure 2
ImPORTaNT
THE RIGHT aND lEFT SIDES OF YOUR RO-
TOTIllER aRE DETERmINED FROm THE
OPERaTING POSITION aS YOU FaCE THE
DIRECTION OF FORWaRD TRaVEl.
ENGINE IS SHIPPED FROm FaCTORY WITH-
OUT OIl. YOU mUST aDD ENGINE OIl BE-
FORE STaRTING ENGINE.
CaUTION
DO NOT TRY TO lIFT THE ROTOTIllER FROm THE
CaRTON.
Figure 1
Figure 3
Lowest Position
Middle Position
Highest Position
handlebar strap
lower handlebar loop
M8 bolts
washers
M8 nuts
lower handlebar loop
M8 bolts
M8 hand knobs
upper handlebar