Includes models w2265 & w2808 vertical / horizontal log splitter assembly & operating instructions om-ws2265-04 rev-030904 © copyright 2004 ardisam, inc. All rights reserved. Printed in usa..
Page 2 one year limited warranty the ardisam, inc., manufacturing company warrants this earthquake ® log splitter to be free from defects in material or workmanship for the normal service life of the product not to exceed 12 consecutive months from the date of purchase. The cylinder, valve, pump and...
Page 3 safety and maintenance safety instructions · before operating this log splitter, carefully read this manual and follow all instructions . • do not allow anyone to operate your log splitter who has not read this manual. • never operate your log splitter for any other purpose than splitting woo...
Page 4 repair and maintenance safety • do not operate your log splitter in poor mechanical condition or when in need of repair. • periodically check that all nuts, bolts, and screws are tightened. • always perform recommended maintenance procedures before using your log splitter. • do not alter your...
Page 5 safety decals part number: lbl4178 description: all general warnings decal location: back of hydraulic reservoir part number: lbl4179 description: towing warning decal location: tongue near trailer hitch coupler part number: lbl4180 description: coupler operating instructions decal location: ...
Page 6 warning: before operating your log splitter, please fully read and understand all safety, maintenance, and assembly instructions outlined in this manual. Become familiar with it for your own safety. Failure to do so may cause serious injury and/or death. Do not allow anyone to operate your lo...
Page 7 4. Attach the wheels to each side of the reservoir (4300) by sliding the end of the spindle into the tubes at the bottom of the reservoir. Make sure that the holes line up as you insert the spindle. Secure in place with two 5/16-18 x 2-1/4” bolts (48300) and two 5/16-18 bi-way locknuts (60g56...
Page 8 model w2265 only 8. Remove the 90 degree street elbow (4122) and the 1” barbed coupler (4160) and insert the street elbow first into the suction screen (4307) that has already been assembled into the reservoir. Tighten the elbow until it faces to the right or engine side of the log splitter w...
Page 9 log splitter assembly instructions note: at least two people are required to lift and assemble the beam to the reservoir. 12. Remove the beam and stand it upright on the foot as it would be in use. Roll the reservoir into position and rotate the reservoir with the tongue until the holes line ...
Page 10 log splitter operating instructions starting important: the engine and hydraulic reservoir are shipped without oil. See the engine operator’s manual packed with your log splitter for the type of crankcase oil, fuel, etc. The engine manufacturer recommends lead-free gasoline only. Caution: do...
Page 11 log splitter operating instructions towing 1. The log splitter is equipped with high speed road tires, a class ii coupler (1-7/8” diameter ball required) and a safety chain. Before towing, the safety chain must be secured to the hitch or bumper of the vehicle and the kickstand rotated to the...
Page 12 log splitter operating instructions maintenance 1. Consult the operating and maintenance instructions of the engine operator’s manual for engine care and maintenance. 2. Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil...
Page 13 log splitter notes ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ _____________________...
Page 14 6.5-hp log splitter parts explosion 4121 4113 4100 4113 4341 4343 4331 4314 4363 (2) 4117 (2) 4337 4328 4362 4125 4101 4331 4117 4353 4314 4363 3305 4352 4142 4379 (4) 509 (6) 4375 4319 2102 (4) 4300 60g56 4339 4153 4099 4156 4155 4157 4159 4154 48300 2102 2104 (4) 4322 60g56 (2) 4321 60g56 ...
Page 15 part no. Description qty. 60g56 locknut, bi-way, 5/16 8 509 bolt, slotted hwh, 1/4-20 x 1/2 6 535 key, 1/4 x 1, 8-hp 1 800 engine-tecumseh, 8-hp 1 2102 bolt, hh, 3/8-16 x 1 8 2104 nut, bi-way hex, 3/8 15 3305 engine-briggs quantum, 6.5-hp 1 4005 hydraulic cylinder, 4 x 24, 8-hp 1 409...
Page 16 log splitter specifications ardisam, inc. 1690 elm street, cumberland, wisconsin 54829 (715)822-2415 • fax (715)822-4180 www.Ardisam.Com maximum splitting force engine cylinder valve pump maximum log length cycle time tires ball hitch wedge beam size reservoir capacity filter height length w...
