EarthQuake WE43 Operator's Manual - page 4
Operator's Manual
WE43 Series Walk-Behind Edger
Check for parts online at
www.getearthquake.com or call 800-345-6007 M-F 8-5
4
GENERAL SAFETY RULES
•
Read, understand, and follow all instructions on the machine
and in the manual(s). Be thoroughly familiar with the controls
and the proper use of the machine before starting.
•
Use this equipment for its intended purpose only.
•
Familiarize yourself with all of the safety and operating
decals on this equipment and on any of its attachments or
accessories.
•
Do not put hands or feet near or under rotating parts.
•
Only allow responsible individuals who are familiar with the
instructions to operate the machine. Do not allow children
to operate this machine. Do not allow adults to operate the
machine without proper instruction.
•
Thoroughly inspect the area where the machine is to be
used and remove all foreign objects. Your equipment can
propel small objects at high speed causing personal injury
or property damage. Stay away from breakable objects, such
as house windows, automobile, greenhouses, etc.
•
Wear appropriate clothing such as a long-sleeved shirt or
jacket. Also wear long trousers or slacks. Do not wear shorts.
Never wear sandals, sneakers, or open shoes, and never
operate the machine with bare feet.
•
Do not wear loose clothing or jewelry. They can get caught in
moving parts. Always keep hands, feet, hair and loose clothing
away from any moving parts on engine and machine.
•
Always wear safety goggles or safety glasses with side shields
when operating the machine to protect your eyes from
foreign objects which can be thrown from the unit. Always
wear a protective hearing device.
•
Always wear work gloves and machine safety shoes during
operation. Wear footwear that will improve footing on
slippery surfaces. Leather work shoes or short boots work
well for most people. These will protect the operator’s ankles
and shins from small sticks, splinters, and other debris.
•
It is advisable to wear protective headgear to prevent the
possibility of being struck by small flying particles, or being
struck by low hanging branches, twigs, or other objects
which may be unnoticed by the operator.
•
Do not operate the machine without proper guards or other
safety protective devices in place.
•
See manufacturer’s instructions for proper operation and
installation of accessories. Only use accessories approved
by the manufacturer.
•
Operate only in daylight or good artificial light.
•
Do not operate product when fatigued or under the influence
of alcohol, drugs or other medication which can cause
drowsiness or affect your ability to operate this machine safely.
•
Never operate machine in wet grass. Always be sure of your
footing; keep a firm hold on the handle and walk; never run.
•
Watch for traffic whenever you are operating near, or when
crossing roads.
•
If the equipment should start to vibrate abnormally, stop the
engine (motor), disconnect the spark plug wire and prevent
it from touching the spark plug. Check immediately for cause.
Vibration is generally a warning of trouble. If the noise or
vibrations of the machine increase, stop immediately and
perform an inspection.
•
Never leave the machine unattended when the engine is
running.
•
Regularly inspect the machine. Make sure parts are not bent,
damaged or loose.
•
Temperature of muffler and nearby areas may exceed 150°
F (65° C). Allow muffler and engine areas to cool before
touching. Never pick up or carry the machine while the
engine is running.
•
Prolonged exposure to noise and vibration from gasoline engine-
powered equipment should be avoided. Take intermittent breaks
and/or wear ear protection from engine noise as well as heavy
work gloves to reduce vibration in the hands.
•
Keep all screws, nuts and bolts tight.
•
Do not transport the machine from one place to another
with the engine running.
•
When moving the packaged machine, always do so with a
partner.
•
Check local regulations for age restrictions on use of this
machine.
PRODUCT-SPECIFIC SAFETY RULES
•
Do not edge above underground utilities, including water
lines, gas lines, electric cables, or pipes. Do not operate the
machine on terrain/soil with large rocks and foreign objects
which can damage the equipment.
•
After striking a foreign object, stop the engine. Remove the
wire from the spark plug. Inspect the machine for damage. If
damaged, repair before starting and operating the machine.
•
The blade of the edger should not rotate when the engine
is idling. If it does rotate when engine is idling, contact
Earthquake® for instructions.
•
If an object becomes lodged in the blade guard area, turn
engine off, remove the wire from the spark plug and secure,
allow to cool before attempting to remove the foreign object.
•
When the unit starts to fire or run, release the throttle control
momentarily with your right hand and return your left hand
to the handlebar position to maintain control and stability
of the unit with both hands.
•
Use edger only for edging along flower beds, terraces,
sidewalks and curbs. Trim along buildings trees, walks,
marker hedges and fences.