EarthQuake XJ-700R User manual - page 8
Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
(10) AC Power with Built-in Fuse
This AC line connector is fused to protect the
amplifier from unwanted power surges. Be
sure to use the proper fuse rating when
replacing the fuse:
115V~60Hz: ø5x20mm, T8AL/250V
230V~50Hz: ø5x20mm, T4AL/250V
To access the fuse compartment, simply
unplug the amplifier
from any power source,
place a flat-head screw
driver in the small notch
and pry it open as
illustrated.
(1) Power Button
(4) Music/Movie Mode Button
Press this button to switch the amplifier ON or
Press these buttons to select the amplifier’s
put it on STAND-BY.
preset EQ
(2) Vol +/- Button
Press these buttons to adjust the gain/volume
of the amplifier.
(3) Mute Button
Press this button to mute and un-mute the
subwoofer connected to the XJ-700R.
Music mode (flat) and preset Movie
mode (+8dB between 30 - 80Hz).
For your convenience, this included remote can be
downloaded into a learning/programmable remote.
IR Code
: 00H FFH
Customer Code : 85229080
8 XJ-700R Manual
(10)
Product Overview - Back Panel (Cont’d)
Product Overview - Remote Control
(1)
(2)
(3)
(4)
XJ-700R
L
R
LFE
BOUNDARY
EQ
CROSSOVER
PHASE
SIGNAL SENSING
MAIN
POWER
+
–
–
SUB 1
ON
0°
40Hz
160Hz
ON
180°
OFF
AUTO
115V
230V
+12V
ON
OFF
SUB 2
115V~60Hz: T8AL/250VAC
230v~60Hz: T4AL/250VAC
FUSE RATING:
+
INPUT
IR
SPEAKER OUTPUT
(CLASS 2 WIRING)
AC SELECTOR
(4-OHM MIN)
(FLAT)
(+3dB)
Designed and engineered
in the USA
(4-OHM MIN)
Earthquake Sound Corp.
Hayward, California
USA