EarthWay 2170T Assembly And Operating Instructions Manual
(Qty 4 #36214)
1/4-20 X 1½”
Phillips Panhead
(Qty 4 #36300)
1/4-20 SS Locknut
36210
Qty 2
36214
Qty 4
31100
Qty 7
31120
Qty 2
*31114
Qty 1
32103
Qty 9
31106
Qty 3
32100
Qty 2
33117
Qty 1
36105
Qty 1
33108
Qty 1
33109
Qty 1
36300
Qty 6
12152
Qty 2
12148
Qty 2
*
Included in Extension Kit
22
28
12
9
10
14
30
6
21
13
7
15
18
44249
1. Remove and identify all loose parts from carton
.
2. Position hopper on side. Install frame using (4) 1/4-20 x 1½” Pan Head Phillips
machine screws and (4) 1/4-20 nylon insert locknuts. First put bolts through holes in
frame then through the holes in bottom of hopper. Secure with locknuts. TIGHTEN
THESE LOCKNUTS NOW......TIP: coat stainless steel bolts with wax or grease
before tightening to prevent them from seizing.
DO NOT TIGHTEN WITH POWER TOOLS.
7-2013 Pt# 52165
PAGE 1
2170T C
ommerCial
T
ow
B
roadCasT
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, EMAIL: TECHSUPPORT@EARTHWAY.COM
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
;
If your spreader does not spread evenly, be sure the word “FRONT” on the gear box points toward the tow bar of the
spreader. The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise.
Clean the impeller surface after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
;
Your spreader is designed to be pulled at three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader
thoroughly after each use. Coat all metal surfaces (inside & outside of chassis) with light oil or silicon spray to help
prevent corrosion. Wash between the shut-off plate and bottom of the hopper.
;
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
OVER
3 MPH
Do not tow
faster than
3 MPH
ROCK SALT and POWDERED MATERIALS
should not be used in this spreader as it will damage
the gearbox and can void the warranty.
Use only granular materials.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
MADE IN THE USA