EarthWay EV-N-SPRED 2170 Assembly And Operating Instructions Manual - page 2
Gearbox Assembly
Drive wheel
Coast wheel
Frame brace
1/4-20 Locknut
Impeller
Cross Brace
Frame
Lower Handle
Bushing
Shut-Off
1/4-20 x 1-1/2”
Hex Head Bolt
Step 6B
Step 6C
1/4-20 x 2-1/4”
Hex Head Bolt
Step 6A
Axle
Foot
Bushing
3. Install impeller onto pinion shaft. Insert 1/8”x 1¼” cotter
pin through impeller then through pinion shaft. Use hole
closest to the gear box. Spread cotter pin to prevent from
falling out.
Next insert Cross Brace thru the Gearbox Brace as shown
above.
FRON
T
Pinion
Shaft
1/8 x 1-1/4”
Cotter Pin (#36105)
Impeller
Cross Brace
GEARBOX ASSEMBLY
Gearbox Brace
FR
ON
T
4. Install gear box by inserting the pinion shaft into hole
in center of hoppers bottom. The word “FRONT” on the
gearbox must point to
Front of the hopper. Follow label
instructions on hopper.
Axle Bearing
Flat
Side
Notch
5. Install axle bearings to both lower
handles.
NOTE: Notch on bearings
and lower handles. Bearings must go
through flat side of lower handle.
6. A - Install lower handles onto axle to both sides as shown. Insert 2¼” bolt through second hole in lower handle and through
first hole in frame install locknut.
DO NOT TIGHTEN.
B - Now insert 1½” bolt through first hole in lower handle. Then through frame brace. NOTE: Numbers on frame brace must
be facing toward gear box as shown. Next into threaded connector in cross brace.
DO NOT TIGHTEN.
Install the Foot into the Frame and align the bolt holes in the Foot and the Frame (a Phillips screwdriver or large nail is helpful
to align the parts)
C - Next insert 1½” bolt through other end of frame brace and through second hole in frame through the foot and install
locknut.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP.
DO NOT OVER TIGHTEN.
PAGE 2