EarthWay EV-N-Spred C22HD Assembly And Operating Instructions Manual

C22HD & C22HDS B

roadcast

 s

preader

ASSEMBLY and OPERATING INSTRUCTIONS

31104 

Qty 4

36300 

Qty 17

36305 

Qty 2

36404 

Qty 18

36200

Qty 4

36205

Qty 3

36207

Qty 2

33117 

Qty 1

36105 

Qty 1

36104 

Qty 1

36103 

Qty 1

36209

Qty 4

For 

C24HD

Only

Upper Handle

Gauge & Lever

Handle 

Shaft

Frame

Brace

Cross

Brace

Lower

Handles

Impeller

Frame

Gearbox

Pivot

Control

Rod

Pivot 

Rod

Axle

(Qty 4) #31104

#14 X 1½”

Flat Head Screw

2. Position hopper on side.  Install 

frame using (4) #14 x 1½” Flat 

Head Phillips screws.   TIGHTEN 

THESE NOW.

1. Remove and identify all of the loose parts from carton.

6-2014 Pt# 52153         PAGE 1

Gauge Overlay is snapped over the 

metal gauge. Replace the stop bolt 

assembly to secure overlay on the 

gauge.

WARNING

Do not use air tools to assemble.  To prevent seizing, 

spray all nuts & bolts with oil, grease, wax, or other 

lubricant.

PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS 

REGARDING THE SAFE OPERATION OF THIS SPREADER.   THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT          

SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: techsupport@earthway.com

HELPFUL HINTS: 

;

If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader.  The impeller must 

turn clockwise.  Reversing the gearbox will cause the impeller to turn counter clockwise.  Clean the impeller after each use as some 

fertilizer may become stuck on the impeller blades and will cause uneven spreading.

;

Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed.  Slower or faster speeds will change 

the spread patterns.  Wet fertilizer will also change the spread pattern and flow rate.  Clean and dry your spreader thoroughly after each 

use.  To prevent rust, please coat all metal surfaces, also inside tubes where possible, with a light oil or WD-40. Wash between the shut 

off plate and bottom of the hopper.

;

Gears are permanently lubricated at the factory.  Do not open the gearbox or dirt may enter.

;

If you use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily.  Rock Salt will 

reconstitute back into a solid block over night and will damage your spreader.

ROCK SALT and POWDERED 

MATERIALS should not be used in this 

spreader as it will damage gearbox and can 

void warranty.  

Use only granular materials.

IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #6

MADE IN THE USA