EarthWay Hand Crank Spreader Setting Instructions

Hand Crank Spreader 

Rate Setting Instructions

To Calculate RATE SETTINGS:

 (Use the chart on page 2 to fill in 

numbers)

5

Determine how much material is to be applied per 1,000 sq./ft. 

This is determined on the bag based on bag weight and total area 

of coverage if not directly stated on the bag the recommended number of pounds per 

1,000 sq./ft.

5

Measure off a distance of 50 feet, preferably on a paved surface such as a parking lot.

5

Weigh out enough of the material to be applied to fill the bag/hopper at least half full. 

5

Record the weight for future use.

5

With the unit positioned correctly for comfortable use, (on your left hip for 2700A/2750 

or on your chest for the 3100/3200 models) and the bag/hopper at least half full of the 

material to be spread, position the yourself far enough before the beginning of the 50 foot test 

area so that you will achieve the desired speed before you reach the starting line.

5

Select the Setting Rate position that you feel would be an appropriate setting on the 

seeder/spreader (start in the middle).

5

Start walking at a NORMAL pace cranking the handle so that it makes 

one revolution for each step with either your right or left foot to 

ensure the proper distribution rate.

5

As you cross the starting line (of the 50 feet) move the rate lever to 

the open position against the stop.

5

Continue from the starting line with the unit spreading the material. 

As you cross the finish line move the rate control lever to the closed 

position.

5

Stop walking and measure the spread width and note it below.

5

Return to the start point and empty the remaining material from the 

hopper into your weighing container and re-weigh.

START

FINISH

Ear

t hW

ay

R

50 FEET

Chest Type

YOU WILL NEED: 

• Tape measure

• Pencil & Pad

• Scale

• Bucket/container

Bag Type

Stop

Rate

Control

Stop

Rate Control

Part# 52198HC