Earthworks C&C30 User Manual - page 8
This is what provides the directional characteristics of a cardioid microphone, in that
it will pick up at the front and the sides and picks up far less at the rear, therefore
making the microphone directional. However, this is textbook theory. This is much
different in practice with real (imperfect) microphones used in the real world.
Figure 9b shows the polar response of a typical conventional cardioid microphone.
Notice at 500Hz, 1kHz and 4kHz the pick-up pattern is almost an omni pattern,
however, these three frequencies are down 10dB in level in reference to their level
at the front of the microphone (0 degrees). In contrast 16kHz and 20kHz are down
15dB at the rear of the microphone. We need to look at one important fact. Which
frequencies are most audible, 500Hz to 4kHz, or 16kHz to 20kHz? Without question
the frequencies between 500Hz and 4kHz are vastly more audible or predominant
than those between 16kHz and 20kHz. This shows that the typical conventional mi-
crophone in Figure 9b will be somewhat less sensitive at the rear of the microphone,
but by only about 10dB in the frequency range between 500Hz and 4kHz.
Looking at the Earthworks cardioid polar response in Figure 9c shows that it has far
more rejection in 500Hz to 4kHz frequency range at the rear, than the conventional
microphone shown in Figure 9b. In Figure 9c, see that 1kHz is down by 30dB or
more, while 500Hz and 4kHz are down 15dB. Also notice that 16kHz and 20kHz
are only down 5dB to 10dB. But remember that these high frequencies are far less
audible than those between 500Hz and 4kHz.
7
(9b) Conventional Cardioid Microphone
(9c) Earthworks Cardioid Microphone
Figure 9. Differences in the Rear Polar Response Between a Perfect,
Conventional and an Earthworks Cardioid Microphone
(9a) Textbook Perfect
Cardioid Microphone
Figure 8 below, shows that it would actually take 12 conventional cardioid micro-
phones to provide the same coverage as 3 Earthworks cardioid microphones, when
placed 3 feet in front of the choir.
Three characteristics of Earthworks microphones will provide more gain before
feedback: (1) Smooth off-axis response, (2) picking up far less sound from the rear
of the microphone and (3) wider usable polar-response that allows microphones to
be placed closer to the source. Each of these characteristics will provide more gain
before feedback, however, when you have all 3 it is somewhat remarkable.
The near-perfect polar response provides a smooth off-axis response in addition to
a much wider pick-up pattern with the full frequency response of the microphone.
With a wider pick-up pattern, the microphone can be moved closer to the source
(in this case singers) and obtain even more gain before feedback.
Spotlighting
Conventional microphones typically have problems with highlighting or spotlight-
ing when used on choirs. This is caused by the significant changes in frequency
response of sounds that are picked up off-axis. This phenomenon will cause singers
in a given frequency range to sound louder than others not in that frequency range.
This causes certain singers to stick out above the rest making it difficult to achieve a
good balance between all of the voices in the choir. In contrast, the uniform off-axis
response of Earthworks microphones greatly reduces this phenomenon allowing a
uniform balance of choir voices to be achieved much easier.
Rejection of Sounds Behind the Microphone
A textbook perfect cardioid microphone will pick up sounds uniformly at the front
and sides of the microphone. However, the level (in dB) on the sides of the micro-
phone will be slightly less (as much as 6dB). Even though the level at the sides of the
microphone may be lower, the frequency response should remain uniform (i.e. no
loss of high frequencies). The textbook perfect cardioid microphone is very dead at
the rear of the microphone. The polar response of a perfect cardioid microphone is
shown in Figure 9a. Notice that at 180 degrees the level is down 30 dB or more.
6
Figure 8. An 80-voice choir miked with 12 conventional microphones at 3 feet