Croquet caddy assembly instructions model 1-1-02341/02347 adult assembly required - product must be assembled by adult before use. Choking hazard - product contains small balls and small parts. Not for children under 3 years..
1 required recommended (not required): tools • 1 - phillips head screwdriver (standard size) - not included • electric screwdriver or power driver caution - do not over tighten. Over tightening will result in irreparable damage to the product. If using, please make sure that the tool is set to a ver...
2 parts identifier hardware x2 60 screw (foot) for step 1 #02341-60lg x10 61 bolt for step 3, 4, 10 #02341-61lg x10 62 nut for step 4, 9, 10 #02341-62lg x4 63 screw (cross supports) for step 6 #02341-63lg x2 64 screw (stake holder) for step 7 #02341-64lg x2 65 long bolt (cross support bar) for step ...
3 caddy construction assembly instructions please review the parts identifier and make sure that you have all parts before beginning assembly. All parts listed in the parts identifier and accessories before building - please inspect and layout all your parts start 1 leg - left x1 2 leg - right x1 3 ...
4 step 3 assembly x1 10 pole x2 61 bolt hardware qty. X4 62 nut x4 step 4 62 61 10 step 3 assembly note: smaller holes are located towards the lower end of poles. Sink hole side should face out. Bolt the poles in. Do not overtighten. B insert poles into step assembly 3. A hardware qty. Step 2 assemb...
5 wiggle the short spacer & mallet head holders down the poles. Do not force. Gently work until poles reach their correct placement. Hardware qty. Step 4 assembly x1 11 short spacer x2 12 mallet head holder x2 step 5 12 11 step 4 assembly slide the cross supports into the designated spot, then inser...
6 snap together. Hardware qty. 16 cross support bar x1 15 mallet handle holder x1 step 8 note: wicket holder is on same side as stake “c” clip. Note: shows finished step 8 assembly 16 15 note: slide step 8 assembly down poles until bolt holes line up hold finger on nut while screwing bolt tight. Do ...
7 hang ball bags on hooks. Hardware qty. 18 ball bag x2 step 10 assembly x1 step 11 18 step 10 assembly step 12 caddy is now assembled. Time to mobilize and organize..
8 mallet construction assembly instructions please review the parts identifier and make sure that you have all parts before beginning assembly. All parts listed in the parts identifier and accessories before building - please inspect and layout all your parts step 13 screw mallet handle (81) into ma...
9 game parts placements assembly instructions mallets x6 ball bags x2 balls x6 stakes x2 wickets x9 caddy x1.
10 limited warranty as described in and as limited by this limited warranty, eastpoint sports, ltd. (the “company”) warrants this game (the “product”) to be free from defects in workmanship and materials for a period of 90 days from the date of original purchase. The term defects shall mean any impe...
Printed in china 1-1-02341/02347 im 185.188 628 route 10, suite #5 whippany, new jersey 07981 • 1-973-585-4747.
