- DL manuals
- Easy-Kleen
- Pressure Washer
- MAGNUM 4000
- Owner's Manual
Easy-Kleen MAGNUM 4000 Owner's Manual
Summary of MAGNUM 4000
Page 1
Magnum 4000 series owner’s manual call 1-800-315-5533 email sales@easyleen.Com ultra gold plus 3600 new 2014.
Page 2: 1-800-315-5533
** hot water pressure washers only easy kleen pressure systems 1-800-315-5533 this manual contains operational information that is specific for hot a n d c o l d water pressure washers. Read the following instructions carefully before attempting to assemble, install, operate or service this pressure...
Page 3: Safety First
** hot water pressure washers only safety first the safe operation of our pressure washing systems is the first priority of easy kleen. This will only be achieved by following the operation and maintenance instructions as explained in this manual and all other enclosed manuals . Important safety inf...
Page 4
** hot water pressure washers only important safety information warning : risk of explosion. Operate only where open flame or torch is permitted. Warning : flammable liquids can create fumes which can ignite, causing property damage or severe injury. Use only #2 furnace oil or diesel fuel in the bur...
Page 5
** hot water pressure washers only important safety information if you need further explanation of any of the information in this manual, suspend any activity involving the equipment and call our toll free number for assistance, 1- 800-315-5533. Warning : risk of injury. Hot surfaces can cause burns...
Page 6: Operating Instructions
** hot water pressure washers only operating instructions 1. Perform pre-start maintenance inspection on all applicable systems prior to operating the machine. This is essential for the safe, effective and efficient operation. You will get optimum performance from your system only if these instructi...
Page 7
** hot water pressure washers only 3. Attach the water source to the water inlet located on the pump. The water source must be attached with a good quality standard garden type hose, 1/2” minimum is required. Connect the male fitting into the female pump inlet swivel fitting, make sure that the inle...
Page 8
** hot water pressure washers only eectrically operated burners – some models generate 12v from the gasoline engine and provide the necessary power for the burner. Others utilize a 120v connection which must be grounded. If you require upgrades or modifications to your existing electrical system in ...
Page 9: Chemical Application
** hot water pressure washers only chemical application downstream chemical injection – standard note: do not remove back flow preventer as chemical may flow back into the potable water source. Ensure the black nozzle is properly fitted at the end of the wand. The chemical injector will not function...
Page 10
** hot water pressure washers only winter pump/coil protection the following procedure must be used when the pressure washing unit is stored at temperatures below freezing. 1. All water must be drained or blown (via compressed air) from system. Connect a short piece of male fitted ½” garden type hos...
Page 11: General Maintenance
General maintenance **burner maintenance repair of the burner is to be done by authorized and trained burner professionals only. General maintenance and care if the water heater is likely to be exposed to freezing weather then it should be winterized with anti-freeze. Circulation of an anti-freeze s...
Page 12: Maintenance Checklist
Maintenance checklist pump daily 1. Check oil for proper level and adjust accordingly. 2. Examine the quality of the oil. 3. Check pump for oil and/or water leaks. 4. Inspect and clean inlet filters. Weekly 1. Examine all fittings, components, hoses, connections, and nozzles for damages, loose parts...
Page 13: Glossary Of Terms
Glossary of terms psi – pounds per square inch. Pressure washers are designed and rated to operate at a specific psi. Operating at pressures exceeding the maximum rating could result in damage to the unit and/or severe personal injury. Gpm – gallons per minute. The orifice on the pressure wand assem...
Page 14
Off – pump – burner switch interrupteur “arrêt – pompe – brûleur” pressure switch pressostat site glass vitrine à niveau electric motor moteur Électrique 10 gal. Fuel tank réservoir à fuel 10 gal. Coil serpentin ek pump pompe ek oil cap bouchon d’huile water inlet entrée pour l’eau chemical injector...
Page 15
Site glass vitrine à niveau pressure switch pressostat thermostat knob règlage du thermostat chemical injector injecteur de produits chimique coil serpentin 10 gal fuel tank réservoir à fuel 10 gal. Electric starter démarreur Électrique gasoline engine moteur à gaz oil cap bouchon d’huile unloader r...
Page 16
Electric motor moteur Électrique water inlet entrée pour l’eau hot water outlet sortie d’eau chaude hot water outlet sortie d’eau chaude water inlet entrée pour l’eau fold down handle poignée dépliante general pump also available (gp) pompe “general pump” aussi disponible (gp) type of oil needed for...
Page 17
22 type of oil pump 30w non-detergent gas engine 10w30 problem possible causes solutions pressure no pressure or very low pressure - metal in oil - dirt in water - wrong nozzle size - examine the oil in the pump to see if there is metal in the oil. - if you find traces or pieces of metal, your pump ...
Page 18
23 burner no hot water - dead battery - damaged thermostat - damaged pressure switch - damaged ignitor - plugged filter or no fuel - make sure your battery is fully charged. - if the battery’s charge is not full, please replace or re-charge your battery. - make sure the thermostat is connected prope...