EasyFire EF4001B Installation & Operating Instructions Manual

Listed by OMNI-Test

Laboratories, Inc.

Report No. 256-S-01-4

Sierra Products, Inc.

5061 Brooks St., Ste B

Montclair, CA 91763

(909) 399-3355

INSTALLER: PLEASE LEAVE THIS MANUAL WITH THE OWNER!!

NOTE: This heater should not be installed in

a bedroom or bathroom.

SAFETY NOTICE

< CAUTION: HOT W HILE IN OPERATION. KEEP

CHILDREN, CLOTHING AND FURNITURE AW AY.

CONTACT M AY CAUSE SKIN BURNS.

< IF THIS HEATER IS NOT PROPERLY INSTALLED,

A HOUSE FIRE M AY RESULT.

< CONTACT LOCAL BUILDING OFFICIALS ABOUT

RESTRICTIONS AND INSTALLATION INSPEC-

TION REQUIREM ENTS IN YOUR AREA.

< FAILURE TO COM PLY W ITH OW NERS' M ANUAL

INSTRUCTIONS W ILL VOID YOUR W ARRANTY!

Please read this entire manual before installation. Save these instructions.

EF4001B AutoLite Pellet Stove Insert

Installation & Operating Instructions

PLEASE READ THIS ENTIRE M ANUAL BEFORE

INSTALLATION AND  USE OF THIS PELLET FUEL-

BURNING ROOM HEATER. FAILURE TO FOLLOW

T H ES E  IN S T R U C T IO N S  C O U L D  R E S U L T  IN

GENERAL INFORMATION

Installation and repair should be done by a qualified

service person. The heater should be inspected before use

and at least annually by a professional service person. More

frequent cleaning m ay be required due to fuel quality,

excessive lint from  carpeting, bedding m aterial, etc. It is

im perative that control com partm ents, burn pot and circulat-

ing air passageways of the heater be kept clean.

The EASYFIRE Pellet Insert has been designed and

approved for burning w ood pellet fuel only. Burning solid

fuel in other form s is not perm itted and will void all warran-

ties.

This unit has been approved for use with a Ø 3" Type L

Pellet Vent System  or Stainless Chim ney Liner (Ø 4" on

runs 10 feet and above).

NEVER use gasoline, gasoline-type lantern fuels,

kerosene, charcoal lighter fluid, or sim ilar liquids to start or

"freshen up" a fire.  Keep all such liquids well away from  the

heater while it is in use.

Ashes m ust be disposed of in a m etal container with a

tight fitting lid and placed on a noncom bustible floor or

ground, well away from  all fuels, pending final disposal.

NOTE :  During the first few burns the high tem perature

paint and sealant used in m anufacture will em it som e odor

and sm oke. Open doors and windows to the outside for

proper ventilation during the first burn cycle and curing of

the paint.

This heater, when installed, m ust be electrically grounded in

accordance with local codes or, in the absence of local

codes, with the National Electrical Code, ANSI/NFPA 70-

2006.