Product instruction manual easymount sign laminator em-720 em-880 the easymount sign has been designed to be user friendly, however we strongly recommend you take a few minutes to read through this manual to ensure correct operation. Keep this manual safe for future reference..
2 contents page 3 - introduction page 4 - safety instructions and environmental requirements page 5 - control panel and specifications page 6 - operating instructions page 7 - threading the film page 8 - cleaning and maintaining the system & spare parts page 9 - warranty.
3 control panel emergency stop roller pressure control tension control rubber roller feed table stabiliser bar core adapter introduction thank you for purchasing the easymount® sign laminator. This easymount® sign laminator is designed to perform and built to last, with its solid heavy duty construc...
4 safety instructions • please ensure that the voltages of the power supply you are using match with rated working voltages before operating the machine • the power supply should be close to the system for convenient use • the power supply should provide reliable protective earthing connection • bef...
5 speed control forward / reverse auto / foot pedal control panel em-720 em-880 max. Laminating width 720mm/28” 880mm/34” max. Mounting thickness 15mm/0.5” laminating speed 3m/10ft / min rated working voltage/frequency 220v-240v, 50hz-60hz rate input power 50w dimensions 940 x 650 x 1250mm / 40 x 26...
6 the photocell will function as follows: • auto: in auto control mode the rollers will stop immediately when the photocell is interrupted. A beep will sound if there is a blockage between the photocell sensor. Once the blockage is removed and you have activated the reset switch, the rollers will be...
7 threading cold film follow the diagram to thread the film: • slide the cold film onto the roll shaft. Hold the cold film on the core adaptor to prevent it rotating. Screw the bolt on the core adaptor, put the roll on the brackets. Make sure both ends are fitted securely. • insert a piece of guidin...
8 cold lamination • adjust the roller pressure hand wheel according to the thickness and the material of the film and the document to reach the optimum pressure. Turning the pressure wheel clockwise to increase the pressure. Turning the pressure wheel anti-clockwise will decrease the pressure. Note....
9 warranty & incorrect use important information your easymount sign laminator should reach you in perfect condition and is guaranteed for 1 year from date of purchase covering defective parts and general wear and tear, this does not cover film jams, misfeeds or other operator related errors, which ...
