EasyonHold USB-PRO Owner's Manual - page 3
Installation
The USB-PRO system will play the built-in generic on-hold message if you remove
the USB drive from the player. Inserting the USB drive will automatically start
playing any messages on the USB drive within 10 seconds.
We recommend stereo 128kHz, 16 Bit .mp3 files for best audio quality.
The USB-PRO will play multiple audio files in alpha-numeric order. All .mp3 files
that are stored on the drive will play. Files must be named with the .mp3 extension
in order to work.
USB-PRO unit (digital player)
USB flash drive
AC transformer (power adapter)
Mounting screw kit with rubber feet
USB extension cable
RCA-type audio cable
3.5mm adapter plug
1. MOUNT UNIT: Mount the digital player to a clean, dry surface using the screws
provided. Locate player within six feet of the telephone system MOH input. For
shelf mounting, apply the non-marring feet to the bottom of the digital player.
2. CONNECT AUDIO: Using the supplied audio cable, connect the 600-Ohm audio
output on the digital player to the music on-hold jack located on the telephone
system. If you cannot find a music on hold input jack on your phone systems (some-
times labeled MOH) contact your telephone technician or installer.
3. CONNECT POWER: Connect the AC wall transformer to the power jack on the
digital player and plug the transformer into a standard 110V wall outlet. Status light
will flash.
4. INSERT DRIVE: Insert the MOH drive into the USB port on the front of the digital
player. Status light will become steady; audio will begin to play within 10 seconds.
5. TEST AUDIO: Depress the speaker on/off switch to hear audio. Speaker may
remain off during ongoing use.
6. ADJUST VOLUME: Call in to system and listen while on-hold. Use the volume
knob on the back of the unit to set proper playback volume.
Contents
Tips
AUDIO CONNECTIONS
most phone systems are configured
to use audio from this jack: 600Ω
^