- DL manuals
- EasyPet
- Pet Care Product
- EP-380R
- User Manual
EasyPet EP-380R User Manual
Summary of EP-380R
Page 1
Easypet ® ep-380r user’s manual rechargeable multi-dog remote training system advanced model of 1200 meter remote range fully waterproof & submersible collar receiver compact, lightweight, and convenient!.
Page 2: Easypet
Easypet ® ep-380r user’s manual rechargeable multi-dog remote training system advanced model of 1200 meter remote range fully waterproof & submersible collar receiver compact, lightweight, and convenient! Please read this manual thoroughly and carefully before operating. Thank you for purchasing our...
Page 3
How the system works consistent and correct use of this remote dog trainer allows you to reinforce commands and correct misbehaviour from up to 1200 meters (in open area). There are 50 groups of warning tones that can be used for praise, warning or silent recall. Or use the remote transmitter to sen...
Page 4: Quick Start Guide
From level 90 to level 99, it has the strongest static pulse stimulation intensity again with different correction durations (from 200ms/0.2 second to 2 seconds). Quick start guide step 1: prepare the remote transmitter handset the transmitter handset should normally have battery power left and you ...
Page 5
Caution! Always use the supplied power adaptor to charge the transmitter. Do not charge the transmitter in an especially hot area. Do not leave charging unattended or charge overnight! If the battery status bar shows full bars ( i.E. 3 bars) and the transmitter is put on charge, the background light...
Page 6
(sometimes accidentally), the collar receiver will not receive the command sent out from the transmitter handset. Correction level indicator: this indicates the level settings of the current correction mode. If it displays "– –" on the correction level indicator (with no numbers), it means the trans...
Page 7
A, b, c (dog channel) buttons: short press on a, b or c button will allow you to choose the dog channel. Step 2: charge the collar receiver caution! Always use the supplied power adaptor to charge the collar receiver. Do not charge the collar receiver in an especially hot area. Do not leave charging...
Page 8
Please cover the charging port with the rubber bung tightly after charging. To insert the rubber bung smoothly back into the charging port, please lift up the bung and make sure the rubber bung is in vertical position (as shown in the following picture). When the battery is low, the led light on the...
Page 9
To turn on the collar receiver , short press the power button three times repeatedly within 3 seconds, a red light will come up each time when the button is pressed down and go off when the button is released. The collar receiver will short bleep once. The collar receiver is now turned on into worki...
Page 10
Step 4: match the receiver with the transmitter collar receiver might have been matched up in to one of the channels on the transmitter handset when it is tested in factory. To check this, please turn on the transmitter handset and collar receiver, send a beep tone command to the collar receiver fro...
Page 11
Long as correction level indicator is not shown as "– –" on the lcd screen (which is the "no transmit" mode for the transmitter). 4.2 make sure the collar receiver is turned on. (the collar receiver will be turned on automatically after the charging or please refer to step 3: turn on/off the collar ...
Page 12
* if the battery inside the collar receiver has been left flat for a long period of time, the collar receiver might lose the matching code memory. Please charge the collar receiver and perform the matching-up procedure again. Caution! Never perform the matching-up procedures while the collar receive...
Page 13
To test the warning tone function, short press the warning tone button on the transmitter and choose a valid correction level for warning tone correction. There are 50 groups of warning tones in different frequencies. (you can choose the desired groups for your dog for different praise and warning p...
Page 14
Stimulation. When trying this on your dog, please always start from the lowest level and increase the level gradually to find out the recognition level for the dog. Short press button t to send out command to dog a collar receiver. Dog a collar will start giving a static pulse stimulation at the sel...
Page 15: Important:
Important: 1. The proper fit and placement of the collar receiver is important for effective training. The contact points must have direct contact with your dog’s skin. Trim the fur if necessary. 2. Please note that the collar receivers are not designed to be worn continuously by a dog. To prevent i...
Page 16: General Training Tips
5. If you have progressed to level 99 while searching for your dog’s recognition level and your dog continues to show no response, check to see if collar receiver is snug against your dog’s neck. Then go back to intensity level 1 (button 1) and repeat the process. If your dog still does not indicate...
Page 17: Troubleshooting
Q2: how old does a dog have to be before using the remote training system? A: your dog should be at least 6 months old and in healthy conditions. Your dog should be able to learn basic obedience commands such as “sit” or “stay”. Q3: once my dog is trained and has been obeying my commands, will my do...
Page 18: Important:
Use a stronger stimulation level. Please note that in very cold weather, you may need to use a slightly higher setting to achieve the same level of intensity. Problem no. 2: the collar receiver cannot be matched up with the transmitter. Please make sure the collar receiver is switched on. When the c...