EasyStand Bantam Owner's Manual - page 17
FIG . A
Height
FIG . B
Plantar/Dorsi
FIG . C
Adduction
FIG . D
Forward/Aft
Knee Pads
FIG . G-The standard knee pads have depth and pad rotation
adjustments only. To adjust the knee pads, loosen the knobs
and move into position. Tighten securely once desired position is
reached.
FIG . H-The Swing-Away Knee pads swing out of the way by
depressing the red button, they also have width and height
adjustments.
Caution: Make knee pad adjustments while child is in the seated
position only.
FIG . G
Standard Knee pads
!
Gas Cylinder
Place foot on the pedal and lift using the assist handle behind the
seat to help raise the unit to the standing position. This may also be
necessary when lowering the user to the seated position.
Foot plates
Caution: Never reposition the foot plates with the child in the
standing position.
Caution: Avoid placing fingers in the adjustment slot.
FIG . A-Height-The standard foot plates have height adjustment only.
Loosen the clamp connecting the foot bracket to the seat post to
adjust foot plate height.
The Multi-Adjustable Foot plates have a wide variety of adjustments:
FIG . B-Plantar/Dorsi-Loosen clamps to tilt foot plates.
FIG . C-Adduction-Loosen clamps to slide foot plates together.
FIG . D-Forward/Aft-Loosen knobs underneath foot plates, slide
foot plates into position.
FIG . E-Toe-in/Toe-out-Loosen knobs underneath foot plates, slide
foot plates into position.
FIG . F-Abduction-Loosen clamps to spread apart foot plates, tighten
clamps. Loosen knobs under foot plates and slide foot plates apart.
Always tighten knobs securely.
!
FIG . E
Toe-in/Toe-out
FIG . F
Abduction
Adjustments & Usage
!
Swing-Away Knee pads
FIG . H
Controller Usage
Designed with ease of use and the safety and comfort of
the user in mind, the Controller as shown is the single
point of operation for the supine option.
41 . The Controller has 3 positions, Sit-to-Stand, Neutral,
and Supine.
42 . There is a spring loaded safety collar (red colored)
which prevents inadvertent switching between modes.
It must be lifted upward into the shift knob before the
mode can be changed.
Sit-to-Stand Mode
43 . With the Controller in Sit-to-Stand mode, the stander
functions conventionally, with the footrest carrier
remaining stationary, always perpendicular to the floor.
The seat raises and lowers, hinged at the knee and at
the hip, with the backrest remaining approximately
perpendicular to the floor, keeping the patients’ torso in
an upright posture throughout the range of movement.
Important: All seat depth and following arm
adjustments should be made with the Controller in
the Sit-to-Stand mode .
41
42
43.
Page 17
Page 14