EasyStand Bantam Owner's Manual - Charging The Battery
Charging the Battery
The EasyStand Bantam Pow'r Up Lift uses two 12 volt sealed lead batteries rated at 2.9 amps each. An
EasyStand Bantam can be lifted approximately 100 times on one full battery charge. An audible alarm will sound
when the battery is low. Please charge your battery after the alarm sounds. A battery needing a full recharge
will take approximately 8 hours. The EasyStand Bantam can be raised to the standing position while being
charged. The function of the charger is to detect a full battery and then provide a constant potential power
supply to hold the battery at a full condition without overcharging. When the battery EMF rises to a factory
preset point, the charger circuit will not allow the peak output voltage to exceed
that value. This factory setting protects a battery from excessive depletion of
electrolyte, which can occur from overcharging. The charger can be found in
the tool pouch on the back of the unit.
CAUTION: Use only the Linak charger, model numbers 00CH01-XX OR
10CH01S-00, provided by Altimate Medical with your Pow'r Up option.
1. Plug the receptacle into a wall outlet. The light on the charger will be green
indicating an open circuit.
2. FIG. A- Plug the charger cord into the side of the hand control. The light on
the charger will turn yellow indicating the batteries are being charged.
3. FIG. B-The unit will arrive to you unplugged from the battery, you need to
plug in the white cord that supplies power to the actuator and the black cord
that supplies power to the remote. The black cord has a notch on it to orient
the connector properly. Fully charge battery before use.
Note: The white cord has a rubber washer on it, which makes it very sticky and
sometimes will not get pushed in completely, make sure to push the cord all the
way into the battery.
4. When the batteries are charged, the light on the charger will turn green.
5. Fully charge the batteries every three months or less during periods of
intermittent or non-use.
CAUTION: The Bantam Pow’r Up Option is not designed for continuous use.
Duty Cycle 5% Max, 1 min. / 19 min.
Raising the Lift - Press the UP (arrow up) button on the hand control to lift the
seat.
Lowering the Lift - Press the DOWN (arrow down) button on the hand control
to lower the seat.
CAUTION: Ensure the cables are attached properly per the instructions for use. Do not allow the cables to drag
on the floor or to catch on objects.
Pow’r Up Lift Option Usage
FIG. A
FIG. B
Pow’r Up Lift Option
Page 19
!
!
!
The hand pendant is a
Type BF applied part.