Eaton E5024E0402 Operating Instructions Manual

MN05401014E

1

español

english

français

deutsch

italiano

Operating Instructions

Electronic Totalizer

E5024E0402

1. Description

•   6-digit adding counter with RESET function

•   Red LED display, character height 8 mm 

[0.31 in.]

•   Display range 0 – 999 999

•   Lead zero blanking

•   Programming via two setting keys on the front

side

•   During programming, the display guides the

user with text prompts

1.1 Safety instructions and warnings

Only use this display

– according to its intended purpose

– if its technical condition is perfect

– adhering to the operating 

instructions and the general 

safety instructions.

1.2 General safety instructions

1. Before carrying out any installation or mainte-

nance work, make sure that the power supply

of the digital display is switched off.

2. Only use this digital display in a way accord-

ing to its intended purpose: 

If its technical condition is perfect.

Adhering to the operating instructions and the

general safety instructions.

3. Adhere to country or user specific regulations.

4. The digital display is not intended for use in

areas with risks of explosion and in the

branches excluded by the standard EN 61010

Part 1.

5. The digital display should only operated if it

has been correctly mounted in a panel, in

accordance with the chapter “Technical data”.

1.3 Use according to the intended 

purpose

The digital display may be used only as a panel-

mounted device. Applications of this product may

be found in industrial processes and controls, in

manufacturing lines for the metal, wood, plastics,

paper, glass, textile and other processing indus-

tries.

Over-voltages at the terminals of the digital dis-

play must be kept within the limits in Category II.

If the digital display is used to monitor machines

or processes in which, in case of a failure of the

device or an error made by the operator, there

might be risks of damaging the machine or 

causing accidents to the operators, it is your

responsibility to take appropriate safety 

measures.

2. Inputs

INP

Dynamic count input. 

RESET

Dynamic RESET input. Linked in parallel to the

red RESET key. Sets the counter to zero.

3. Setting of the operating pa ra me ters

a. Press both front side keys and switch on the

supply voltage or, if the supply voltage is

already on, press both keys simultaneously 

for 5 s.

b. The display shows

c. After releasing the keys, the display shows

!

MN05401014E:MN05401014E  2/9/07  1:26 PM  Page 1