Eaton EUX Universal Edge Lit Exit Lens Installation Instructions Manual

INS #

049-240

Installation Instructions for the EUX Universal Edge Lit Exit – Battery Backup 

Instructions d’installation pour enseigne de sortie à éclairage périphérique 

universel EUX - Pile de secours

Instrucciones de instalación para la señal de salida universal de iluminación de 

borde EUX  -Batería de respaldo

 WARNING 

Risk of Fire/Electric Shock

If not qualified, consult an electrician.

 WARNING 

Risk of Electric Shock

Disconnect power at fuse or circuit breaker before 

installing or servicing.

Important Safeguards

WHEN USING ELECTRICAL EQUIPMENT, BASIC 

SAFETY PRECAUTIONS SHOULD ALWAYS BE 

OBSERVED INCLUDING THE FOLLOWING.

1.  READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2.  Dry location only. Do not use outdoors.

3.  Do not use in hazardous locations, or near gas or 

electric heaters. 

4.  Do not let power supply cords touch hot surfaces.

5.  Use caution when servicing batteries. Battery 

acid can cause burns to skin and eyes. If acid is 

spilled on skin or in eyes, flush acid with fresh 

water and contact a physician immediately.

6.  Do not use this equipment for other than the 

intended use. 

7.  Installation is to be performed only by qualified 

personnel. 

8.  Install in accordance with National Electric Code 

and local regulatory agency requirements. 

9.  The use of accessory equipment not 

recommended by the manufacturer may cause 

an unsafe condition. 

10. Equipment should be mounted in locations and 

at heights where it will not readily be subjected 

to tampering by unauthorized personnel.

11.  SAVE THESE  INSTRUCTIONS

For Recessed Installation

1.  Turn off power supply. 

2.  Determine if the fixture will be mounted in the 

ceiling or the wall. 

3.  Remove the screws securing the trim plate to the 

housing (See Figure 1). Place the trim assembly 

and screws aside and save them for later 

installation. It is not necessary to disconnect the 

wire harness connecting the charger driver circuit 

board to the LED board. Instead, the trim plate 

can be hung from the sliding plastic installation 

hook (see figure 2).  

4.  Determine where supply wires will be brought 

into the fixture. There are knockouts in each 

endcap on the side of the housing, and a hole 

between the hanger bars. If the hole between the 

hanger bars is to be used, remove the two screws 

holding the cover plate and the hanger bars, 

discard the plate, and then replace the screws 

and hanger bars.

Housing

Plastic

Installation

Hook

Trim

Assembly

Figure 2

Trim Plate

Housing

Figure 1