Eaton HomeHeartbeat User Manual
IM00416008E Rev. 2
Part No.: 67A5006H02
© 2006 Eaton Corporation
Range Extender Uses:
Range Extender Components
Range Extender
Home Key
™
Slide Channel
Antenna
Plugs into
standard
grounded
outlet
(3-prong)
Status LED
Expand the transmission zone to reach sensors
that are farther away from the Base Station.*
Perfect for:
• Large houses
• Houses with thick walls and floors
• Houses with obstructions
*Actual range may vary, depending on the location of
the Base Station and home construction.
FCC Statement
(Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING (Part 15.21): Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
To comply with FCC’s RF exposure limits for general population/uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the
Industry Canada technical specifications were met.
Interference
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, then the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into a power source on different circuit than the receiver.
Sensor Maintenance
No serviceable parts. Clean with a soft, dry cloth.