Eb Brands XC9893 User Manual - Charging The Helicopter
ACTIVATING GLOW IN THE DARK FEATURE
Energize the Glow Copter’s glow in the dark body by using a bright light
source (e.g. next to the window on a sunny day or under a table lamp) for
10 minutes. Please be sure that the helicopter is turned off. Caution: Do not
leave the Glow Copter unattended under direct sunlight for a prolonged
period of time.
BATTERY INSTALLATION & CHARGING
Installing Batteries in the Remote Controller
1. Using a Phillips-head screwdriver, remove the screw from the battery
compartment cover.
2. Insert 6 AA batteries, making sure to follow the battery polarity
(+ and -) drawing on product.
3. Replace the battery compartment cover and secure with the screw.
4. Turn on the remote. If the batteries are properly installed, the Red LED light
will blink. If the Red
LED does not come on
when you turn the
remote on, remove
the batteries and
reinstall. Some brands of batteries have small size variations that can
impact the connection.
Charging the Helicopter
1. Make sure the controller is turned ON.
2. Pull the cover off the front center of the
controller, and take out the charging wire.
3. Make sure the helicopter power is OFF.
Insert the charging plug into the
charging outlet on the helicopter.
4. The Green LED on the remote will turn on
while charging and turn off when charging is
complete. When fully charged, remove plug
from the helicopter. REQUIRES
APPROXIMATELY 40-45 MINUTES CHARGE
FOR A 4 MINUTE FLIGHT.
OFF ON
Charging
Outlet
3
ON/OFF
Switch
BOTTOM OF HELICOPTER
XC9893IS01JCPRA.indd 3
XC9893IS01JCPRA.indd 3
7/12/12 9:18 AM
7/12/12 9:18 AM