Quad twister remote control helicopter user guide #xc6392 © 2011 eb excalibur, inc. Xc6392is01exc 5 x 7 7/24/11 save these instructions. Read complete instructions before use. Xc6392is01exc.Indd 1 xc6392is01exc.Indd 1 8/8/11 2:29 pm 8/8/11 2:29 pm.
2 helicopter layout controller layout power switch stabilizer tail rotor landing gear rotor blade rotor blade band selector throttle stick power switch charging wire trim control knob direction joystick power indicator xc6392is01exc.Indd 2 xc6392is01exc.Indd 2 8/8/11 2:29 pm 8/8/11 2:29 pm.
3 c ongratulations on your new exrc™ purchase! Exrc™ pilots experience superior remote control fl ight and excellence in the look and feel of our products while commanding the skies. Now that you are an honorary exrc™ pilot, we recommend reading through this manual thoroughly before attempting your ...
Flying your helicopter getting started • set the frequency band on the control to match the helicopter. • switch the helicopter’s on/off switch to the on position. The power light will turn on. • extend the antenna on the controller completely. • place the helicopter on the ground with the tail poin...
5 direction control - trim knob located on the top of the controller is the trim control. When the helicopter does not drive or fl y straight, use the trim control to adjust the alignment. 1. Clockwise rotation - when the helicopter is spinning counter- clockwise, turn the rudder trim knob clockwise...
6 • always keep focus on your helicopter, and do not attempt to fl y/land/or crash anywhere on or near any other people or animals. • the rotating parts on the helicopter could lead to injury. Never put any body part including the hands and face, close to the rotating parts. Only operate this produc...
7 care & handling • do not submerge in water or other liquids. • do not disassemble the product for any reason. • do not expose to extreme temperatures. • do not drop, throw, smash or otherwise cause physical shock. • clean using only a slightly damp cloth. • do not use cleaners with chemical agents...
Fcc part 15 compliance the device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ch...
