EB Excalibur US5918 User Manual - page 2
2
C
ongratulations on your new EXRC purchase! EXRC pilots experience
superior remote control fl ight and excellence in the look and feel of our
products while commanding the skies. Now that you are an honorary EXRC
pilot, we recommend reading through this manual thoroughly before
attempting your fi rst fl ight. Inside this manual you will fi nd fl ight tips, safety
precautions, and care instructions to keep your EXRC helicopter in tip-top
shape for multiple fl ight missions.
No need to make sure your seats and tray tables are in the upright and locked
position, no need to worry about loss of cabin pressure, and no fl ight
attendants to do a fi nal check before air-craft take off . Just follow the
instructions, enjoy your EXRC helicopter to the fullest and command the skies.
BATTERY INSTALLATION & CHARGING
Installing Batteries in the Remote Control:
1. Using a Phillips-head screwdriver,
remove the screw from the
battery compartment cover.
2. Insert 6 AA batteries, making
sure to follow the battery
polarity (+ and -) drawing
on
product.
3. Replace the battery compartment
cover and secure with the screw.
Charging the Helicopter:
1. Pull the cover off the side compartment of the
controller, and take out the charging wire.
2. Turn the helicopter power OFF. Insert the
charging plug into the socket on the
helicopter.
3. The LED will turn red when charging. When
the product is fully charged, the LED will turn
green. Remove the plug from the helicopter.
Note: If the LED begins to twinkle, the batteries
are running low on power and should be replaced.
Requires approximately
20-30 minutes charge for
a full 5-6 minute fl ight.
Charging Wire
Compartment
US5918IS01EXC.indd 2
US5918IS01EXC.indd 2
7/8/11 4:35 PM
7/8/11 4:35 PM