Phantom eagle remote control helicopter user guide #xc9977 © 2011 eb excalibur, inc. Xc9977is01exc 5 x 7 7/14/11 save these instructions. Read complete instructions before use. Xc9977is01exc.Indd 1 xc9977is01exc.Indd 1 8/24/11 2:43 pm 8/24/11 2:43 pm.
2 helicopter layout controller layout band selector / power switch throttle stick cover and charging wire trim control knob direction joystick power indicator power switch charging socket stabilizer connecting shaft tail rotor landing skid main rotor blade light xc9977is01exc.Indd 2 xc9977is01exc.In...
3 c ongratulations on your new exrc™ purchase! Exrc™ pilots experience superior remote control fl ight and excellence in the look and feel of our products while commanding the skies. Now that you are an honorary exrc™ pilot, we recommend reading through this manual thoroughly before attempting your ...
Flying your helicopter getting started • set the frequency band on the control to match the helicopter. • switch the helicopter’s on/off switch to the on position. The power light will turn on. • place the helicopter on the ground with the tail pointed toward you and the nose facing away from you. •...
5 direction control - trim knob located on the top of the controller is the trim control. When the helicopter does not drive or fl y straight, use the trim control to adjust the alignment. 1. Clockwise rotation - when the helicopter is spinning counterclockwise, turn the rudder trim knob clockwise t...
6 safety tips • read the entire manual before attempting to pilot your helicopter. • this product is intended for indoor use, and works best indoors. We do not recommend using the product outdoors. • never attempt to fl y your helicopter in a cluttered space. This helicopter was intended for obstacl...
7 troubleshooting (continued) care & handling • do not submerge in water or other liquids. • do not disassemble the product for any reason. • do not expose to extreme temperatures. • do not drop, throw, smash or otherwise cause physical shock. • clean using only a slightly damp cloth. • do not use c...
Fcc part 15 compliance the device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ch...
