EB Excalibur XC9980 User manual - page 3
3
DIRECTION CONTROL - TRIM SWITCH
Located on the bottom of the vehicle is the Trim Switch (5). When the vehicle
does not drive straight, use the Trim Switch to align the wheels.
FUNCTION
USING YOUR ROCKIN’ ROADSTER RC
1. Turn the vehicle on by sliding the ON/OFF (4) switch to the ON position.
This switch is located on the bottom of the vehicle.
2. Turn the controller on by sliding the ON/OFF (17) switch to the ON
position. This switch is located on the front of the controller.
3. Extend the controller’s antenna (10) for best performance.
4. Use the Forward/Reverse buttons (11) to accelerate forward or in reverse.
5. Use the Left /Right buttons (12) to steer the car in either direction.
ROCKIN’ ROADSTER DANCING FUNCTION
Press the Dancing Button (16) located on the center of the remote control to
activate the Rockin’ Dancing motion and music.
INTERFERENCE
Some radio frequencies or other R/C units nearby can cause interference and
poor performance. Try to move away from the source of the interference.
CARE & HANDLING
• Do not submerge in water or other liquids.
• Do not disassemble the product for any reason.
• Do not expose to extreme temperatures.
• Do not drop, throw, smash or otherwise cause physical shock.
• Clean using only a slightly damp cloth.
• Do not use cleaners with chemical agents.
• Do not short-circuit the battery terminals.
CAUTION – Battery Safety Information
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries must be removed before recharging
• Rechargeable batteries should only be recharged under adult supervision
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium)
batteries
• Exhausted batteries are to be removed
• Do not mix old and new batteries
XC9980IS01EXC.indd 3
XC9980IS01EXC.indd 3
6/27/11 3:12 PM
6/27/11 3:12 PM