EBASS DB 510 User Manual - page 5
POWER: Power switch.
AC INPUT: ac input.
115/230 VOLTE: switch to select 100-115 V AC (Japan, North America
..) of 220/240V AC (Europe etc)
ARCO DB 510 can be used anywhere in the world.
WARNING! ! ! Must be used with care! ! ! !
Connect 230 volts to 115 volts switch in position, the amplifier can
be damaged. Responsibility of the user, warranty! ! !
EXTSPKR: connectors for extra speaker. Jack socket and speakon
connector ( 1- and 1+) are in parallel, lowest impedance for external
speaker is 8 ohms. The built in speaker is not interrupted, and thus
is always active.
TUNER: connection for tuner. (See MUTE).
INSERT: output and input for external effects unit, stereo jack, ring
= send , tip = return.
LINEOUT: unbalanced line output to PA or recording.
BAL OUT: balanced line output with XLR jack for PA or recording. (See
PHASE)
Technical Data:
Height 38 cm. Width 36 cm. Depth 30 cm/25 cm. Weight 9 kg.
Mains voltage: 100/240 volts AC 50/60 HZ. MAX 550 watts.
Output power 500 watts into 4 ohms, 250 watts into 8 ohms.
Speaker: 10 inch 8 ohm Neodymium 250/500 watts. RMS / PEAK.
Amplifier 500 watts 4 ohm class-d, switch mode power supply
Cabinet 12mm birch ply, special structures.
Input 1 high sensitivity 2 Mohm.
Input 2 low-sensitive 100 kOhm.
LOCUT - 12 db at 30 hz.
HI CUT - 12 dB at 10 Khz
BASS + / - 15 db at 70 Hz (quasi shelving)
LO MID + / - 20 db at 250 hz
HI MID + / - 15db at 800 hz
TREBLE + / - 15db at 4Khz (quasi shelving)
EXTSPKR jack / speakon parallel coupled minimum impedance 8 ohms
TUNER 0.775 volts
INSERT 0.775 volts
LINE OUT + 4db
BAL OUT +4 dB