EBENCH KH 2329 Operating Instructions Manual - page 7
- 5 -
e-bench
KH 2329
Connection
➭
Connect the antenna cable of the
indoor antenna "TV"
to the anten-
na jack of your television set.
➭
When you want to use the room an-
tenna for radio reception, utilise the
Adapter Coaxial socket/Coaxial socket
.
➭
Connect the Adapter Coaxial
socket/Coaxial socket
with the
antenna cable.
➭
Connect the anntenna cable with
Adapter Coaxial socket/Coaxial socket
to the 75 Ohm connectore on your
stereo system.
➭
To connect the room antenna to a
DVB-T-Receiver with an F-socket, the
Adapter F-Plug/Coaxial socket
must
be used.
➭
Connect the Adapter F-Plug/Coaxial
socket
with the antenna cable.
➭
Screw the antenna cable with the
Adapter F-Plug/Coaxial socket
to
the F-socket of the DVB-T-Receivers.
➭
Insert the power plug of the indoor
antenna into the power socket.
Operating the Indoor Antenna
Receiving programme signals via the
indoor antenna
The programme signals are received by
the indoor antenna and transmitted to
the television set.
For the reception of DVB-T programme
signals you need an additional DVB-T re-
ceiver (DVB-T signals cannot be received
everywhere).
The indoor antenna has to be positioned
correctly for the proper reception of
programme signals.
The following antennas are available for
this:
two telescoping antennas for VHF
and UKW reception that tilt and rota-
te by 180° and
one oval-shaped antenna for UHF re-
ception that tilts and rotates by 100°.
To orient the indoor antenna:
➭
Pull out both telescopic antenna
➭
and adjust these until the best recep-
tion is obtained.
➭
Adjust the oval antenna
by turning
or tilting until the best reception is
obtained.
IB_KH2329_E801_UK_V1 12.12.2006 16:27 Uhr Seite 5