Eberspächer 22 1000 32 26 00 Installation instructions manual - page 3
3
D
S
GB
F
Operating the heater via the numeric
keys on the telephone
You first have to set up a connection between the
telephone and the
CALLTRONIC.
To do this, dial the
number assigned to you by
your network operator.
The
CALLTRONIC signals the following text:
“Eberspächer heater – Input PIN“.
Now enter the 4-digit PIN No.
(The PIN is set to 0000 in the works).
The following 3 operating modes
are available
Note:
If malfunctions occur in the heater during operation
(e.g. due to a lack of fuel), these can be interro-
gated after the malfunction has occurred using
Function 6 (where the diagnosis cable is connected).
The malfunction is corrected with the aid of the
operating instructions for the heater.
1. Stand-alone operation
The function keys 0 to 7 are active at the telephone
(see the following table).
The push-button installed can be used to switch the
heater on or off. If the heater is switched on using
the push-button, the heating function is activated
with a duration of 40 mins. The push-button also
functions without a SIM card. The push-button
flashes if an error occurs in the heater.
2. Combination with mini clock
The function keys 0 to 3 and 5 to 7 are active (see
following table).
The functions of the function key 4 (Select operating
mode) are taken over by the mini clock (see installa-
tion and operating instructions for the mini clock).
When switching on the heater via the mini clock, the
operating mode last set with the mobile phone is
always activated. If a malfunction occurs in the
heater, the reading in the mini clock display changes
between the time and “--“.
If the
CALLTRONIC is connected with the mobile
phone, “--“ appears in the mini-clock display.
3. Combination with
mini controller
When combined with the
CALLTRONIC, the mini
controller only serves to specify the set value.
Select heating mode at the mini controller. The red
LED in the mini controller only serves as an operat-
ing display – not as an operating mode display – the
operating mode is selected via the remote control.
If the PIN No. is wrong, the following message
appears:
“PIN invalid“.
You now have the opportunity to enter the correct
PIN No.
If the PIN No. is correct, the following message
appears:
“PIN OK – Input command“.
You can now enter your settings for the heater via
the
CALLTRONIC.
The following table on Pages 4 and 5 shows which
functions are available to you.