Eberspächer 801 Operating Instructions - page 3
Diagnostic Readout
With the heater switched on, press and hold key until the display shows
‘dA’. The blue LED will briefly illuminate. Release the key. After a short time
the LED flickers momentarily during diagnostic data transfer then goes off. The
display shows FO followed by its fault code then automatically scrolls through
any previously stored fault codes, up to a maximum of 5.
Typical fault codes:
10 = Over voltage - Check battery charging system.
11 = Under voltage - Check battery voltage.
12 = Overheating - Check air ducts for obstruction.
52 = Safety time exceeded - Check fuel supply.
For other fault codes consult your local Eberspächer dealer.
Press and keys together to erase stored fault codes and display shows
‘EE’. To exit diagnostic mode, press and release the key.
If stored fault codes cannot be erased consult your local Eberspächer dealer.
Ventilation
To activate Ventilation Mode, press and hold the key until the blue LED
illuminates and display shows active rotating two digits.
Note: The 801 10 001 version will only run for a maximum period of 1 hour.
To stop ventilation, press key briefly. Blue LED switches off and display
shows ambient temperature.
Technical Specification
Dimensions (mm)
65(w) x 55(h) x 17(d)
Weight
60 grams
Temperature Range
5°C to 32°C
Heater Switched Output
1 amp
Voltage
12 / 24 volt D.C.
Ambient Temperature
Range (Operating)
-30°C to +85°C
Cable Lead
250mm long with pre-crimped Amp Junior Tabs.
Mating terminals / housings supplied loose.