EBike KT-LCD1 User Manual
KT-LCD1 eBike Display User Manual
V2.5
Dear customer, please read this manual before you use KT-LCD1 instrument. The manual will guide
you use the instrument correctly to achieve a variety of vehicle control and vehicle status display.
Functions and Display
1
UP Button
6
TM
Single trip time
2
SW Button
TTM
Total trip time
3
DOWN Button
7
6Km/H push power assist
4
Battery capacity indicator
8
Km
Distance(
metric
)
5
Km/H
Riding speed(
metric)
Mil
Distance (
imperial
)
MPH
Riding speed (
imperial)
DST
Trip distance
MXS
MAX speed
ODO
Total distance
AVS
Average speed
9
ASSIST
Pas level
Operation
1. ON/OFF
Hold
button long to turn on the power, and hold
long for a second time to turn off the
power. When the motor stops driving and when the e-bike is not used for a consecutive 5 minutes, it will
automatically shut down and turn off the motor power supply.
2. Display interface
Hold
button to start up and enter display interface.
2.1 Turn on backlight and headlights
Hold
long to turn on backlight and headlights (the controller should have headlight drive
output function); hold
long again to turn off the backlight and headlights.
2.2 Assist ratio gear (ASSIST) switch
Hold
or
shortly to switch 1-5 file gear. Gear 1 is for
the minimum power, gear 5 is for the highest power. Each startup
will automatically restore the gear shutdown last time. Gear 0 is
without booster function.
2.3 6Km/H assist promotion function
Hold
and
flashes, the vehicle drives at the speed
not more than 6Km/h. Release
button, the function is
invalid.
2.4 Display and delete of single data
After power on for 5 seconds, hold
and
at the
same time, single trip riding time (TM) and single trip distance
(DST) flash, hold
button shortly, the content of both is
cleared. If failed holding the button within 5 seconds, it will
automatically return the display interface after 5 seconds, original
content is preserved.
2.5 Display of
total trip time and
distance
Hold
button shortly to display of
total trip time (TTM)
and
total trip distance (ODO). hold
button shortly again to
return the display interface.In the riding mode after 5 seconds,
automatically returns to display interface.
2.6 Display of single maximum speed and average speed
In the display of
total trip time and
distance, hold
or
shortly to display of single maximum speed (MXS)and
average speed (AVS). hold
button shortly again to return the
display interface. In the riding condition, 5 seconds later,