EBike KT-LCD3 User Manual
KT-LCD3 eBike Display User Manual
V1.0
Dear customer, please read this manual before you use KT-LCD3 instrument. The manual will guide
you use the instrument correctly to achieve a variety of vehicle control and vehicle status display.
Functions and Display
Instruments using the structure form of instrument body portion and the operation buttons are
designed separately.
1
UP Button
10
6Km/H push power assist
2
SW Button
11
Km/H
Riding speed(
metric)
3
DOWN Button
MPH
Riding speed (
imperial)
4
Battery capacity indicator
MXS
MAX speed
5
Backlight and headlights
AVS
average speed
6
The brake display
12
Km
distance(
metric
)
7
TM
Single trip time
Mil
distance (
imperial
)
TTM
Total trip time
DST
Trip distance
8
MOTOR W
Power display
ODO
Total distance
MOTOR
℃
℃
℃
℃
Motor
temperature
VOL
Battery voltage
MOTOR
℉
℉
℉
℉
Motor
fahrenheit
13
ASSIST
Pas level
9
℃
℃
℃
℃
Environment temperature
CRUISE
Cruise
℉
℉
℉
℉
Environmentfahrenheit
Operation
1.
ON/OFF
Hold
button long to turn on the power, and hold
long for a second time to turn off the
power. When the motor stops driving and when the e-bike is not used for a consecutive 5 minutes, it will
automatically shut down and turn off the motor power supply.
2.
Display 1
Hold
button to start up and enter display 1.
2.1 Turn on backlight and headlights
Hold
long to turn on backlight and headlights (the controller
should have headlight drive output function); hold
long again to turn
off the backlight and headlights.
2.2 Assist ratio gear (ASSIST) switch
Hold
or
shortly to switch 1-5 file gear. Gear 1 is for the
minimum power, gear 5 is for the highest power. Each startup will
automatically restore the gear shutdown last time(the user can set
randomly). Gear 0 is without booster function.
2.3
6Km/H assist promotion function
Hold
and
flashes,the vehicle drives at the speed not more
than 6Km /h. Release
button,the function is invalid.
2.4
Cruise function
After the cruise function is turned on, the trip riding speed is greater
than 11 km/ h, hold
long and enter cruise, the CRUISE lit. Brake or
hold any button to cancel.
2.5
Display and delete of single Data
After power on for 5 seconds, hold
and
at the same time,
single trip riding time (TM) and single trip distance (DST) flash, hold
button shortly, the content of both is cleared. If failed holding the
button within 5 seconds, it will automatically return the display interface after 5 seconds, original
content is preserved.
3.
Display 2
Hold
button shortly in display 1 to enter display 2.
In the riding mode after 5 seconds, display 2 automatically returns to display 1, and the
originalmotor power (MOTOR W) display is replaced with motor operating temperature display