Service manual t t m m - - 5 5 5 5 0 0
Copyrights ©2010 all rights reserved. The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer. This document contains proprietary information protected by copyr...
Contents ii contents copyrights .................................................................................................I liability disclaimer ...................................................................................I contents..........................................................
1. Before you start 1. Please unplug the power cable before you start to work. 2. Please read and follow the instructions in this document carefully. Failure to follow these instructions could damage your device and void the warranty. 1.1. Tools suggested all procedures in this document require the ...
Chapter 2 2 2. Base unit separating 1. Adjust the main unit to the position as shown below. 2. Loosen and remove the four screws fixing the base unit by #1 phillips screwdriver. 3. Remove the right hinge cover, left hinge cover and support cover as shown below..
4. Remove the base unit. Chapter 2 3.
Chapter 3 4 3. T t h h e e m m a a i i n n u u n n i i t t 3.1. Opening the device 1. Loosen and remove the twelve screws fixing the back cover by #1 phillips screwdriver. 2. Remove the back cover. 3.2. Emi ad cover disassemble 1. Loosen and remove the twelve screws fixing emi ad cover by #1 phillip...
3. Open the emi ad cover. 3.3. Component and cable disassemble 1. Unplug : 1. Touch control board cable, 2. Osd & indicator cable, 3. Speaker cable, 4. Inverter cable and lvds cable. 2. Loosen the four screws and remove the ad board. 3. Unplug the two connecters from the touch control board. Chapter...
Chapter 3 6 4. Loosen the two screws and remove the touch control board. 5. Unplug the three connecters from the lcd panel inverter. 6. Loosen the two screws and remove the lcd panel inverter..
7. Loosen the screw and remove the msr cable. 8. Loosen the four screws and remove the speaker assembly.. 9. Unplug the led indicator assembly. 10. Loosen the two screws and remove the led indicator lens. Chapter 3 7.
Chapter 3 8 11. Loosen the ten screws. 12. Take out the lcd touch panel assembly 13. Loosen the four screws on the back of the lcd touch panel assembly.
14. Loosen the three screws fixing the touch panel. 15. Remove the touch panel and take out the lcd panel. Chapter 3 9.
