EBS -1 version two User Manual - page 12
C
OMP
/L
IMIT
B
ALANCED
O
UTPUT
12
13
COMP/LIMIT - A very low noise and fast
compressor/limiter that limits level peaks
in play. This compressor will attenuate the
signal and avoid distorting the unit when
approaching the headroom limit.. A string
may be plucked very hard and fast, without
any greater difference in level or side
effects.
The COMP/LIMIT knob sets the com-
pression ration, i.e. the level relation be-
tween the input and output. The higher the
ratio the more compression.
The LED intensity dynamically indicates
the amount of active compression.
COMP/LIMIT - En mycket lågbrusig och
snabb kompressor/limiter som utjämnar
toppar likt en stötdämpare. En sträng kan
slås an mycket snabbt och kraftigt utan att
nivån förändras nämnvärt från det lugna
spelandet. Det betyder också att distorsio-
nen reduceras eftersom nivån blir jämnare.
COMP/LIMIT-ratten bestämmer komp-
ressionsgraden, d.v.s. förhållandet in/ut för
kompressorn. Ju högre förhållande desto
mer kompression.
Lysdioden
indikerar
dynamiskt
hur
mycket kompressorn arbetar.
-9
-3
3
9
dB
12
9
3
-3
-9
dB
OUT
1:1
3:1
Threshold
(Internal)
IN
COMP/LIMIT
(RATIO)
SPECIFICATIONS
Compressor Gain
0 dB
Attenuation
max
24 dB
Compression Ratio
max
3:1
Attack (80%)
typ
<10 ms
Release (80%)
typ
100 ms
Distortion
@ 1 kHz / 0 dBv
0.04 %
@ 1 kHz / +15 dBv
0.21 % max comp. 0.04 %
@ 10 kHz / +15 dBv
0.22 %
Remote:
Connection
TIP on REMOTE input jack
Function
Connect to ground for bypass
Current
12 mA suitable for LED
Threshold
0.7 V
BAL.OUT - High quality line output. De-
signed electronically floating, which
means the output always will adapt itself
when sending to an asymmetrical device
such as an unbalanced input, to keep a
correct balancing and level.
The signal strength from BAL.OUT is
selectable between line level or micro-
phone level with DIP-switch no 1.
Lifting the ground is a great aid in
many occasions. When required, set the
DIP-switch no 2 to lower position, OFF, to
disconnect the ground from the output.
EQ - The BAL.OUT signal may be
taken pre filter (PRE), post filter and com-
pressor (POST), or simply be shut off with
OFF:
In the POST position you can also
utilize DIP-switch no 3 to take out the
signal from post effects loop as well. With
effects (default position, ON), or without
effects (OFF position).
BAL.OUT - Linjeutgång av mycket god
kvalitet. Innehåller en elektroniskt s.k.
flytande balansering som vid asymmetrisk
mottagning i mixerbord, bandmaskin eller
dylikt är självinställande för att ge en alltid
perfekt signalöverföring.
Signalstyrkan ut från BAL.OUT kan
ändras mellan linje eller mikrofon-signal-
nivå med hjälp av DIP-omkopplare nr 1.
Jordlyft är till god hjälp när jordbrum
uppstår. Ställ DIP-omkopplare nr 2 i ner-
fällt läge, OFF, för att koppla från jorden.
EQ - Signalen till BAL.OUT kan tappas
före filter (PRE), efter filter och kompres-
sor (POST), eller helt enkelt stängas av
med OFF.
I POST-läget kan även DIP-omkopplare
nr 3 användas för att tappa signalen efter
effektloopen (uppfällt läge, ON), eller utan
effekt (OFF-läge).
SPECIFICATIONS
Output Level
+4 or -30 dBm
Output Impedance
<10 ohms current limited
Frequency Response
+0 / -3 dB
35 - 50k Hz
Noise Level
linear
-87 dBv
A-weighted
-92 dBv
Dynamic Range
linear
109 dB typ
A-weighted
112 dB min
Measurements made post compressor and effect loop with unity gain in bypass position.
NOTE: The BAL.OUT output may with great advantage be
connected directly into a multitrack taperecorder for best results.
This is thanks to the very high specifications of the EBS-1V2,
and can properly be compared with those of high end audio
mixing consoles.
NOT: Tappning från BAL.OUT kan med fördel göras rakt in i
multikanalsbandspelare tack vare EBS-1V2s höga prestanda.
EBS-1V2 kan och bör jämföras med professionella mixerbord av
högsta klass.