EC Pedals Superswitcher User Manual - page 4
Bank - The SuperSwitcher has 3 banks which will give you 3X7 presets for a total of 21
presets.
Remember - when pressing the Edit button to be on the Bank you want to edit.
Bypass\Edit - On “Play” mode this button act as a bypass switch - no matter which preset is
on and which pedals are on when you press the Bypass button all Loops are disconnected from
the audio chain and the Superswitcher is canceled as once - making your guitar plugged from the
Input jack straight to the Output jack of the SuperSwitcher.
Tuner\Mute- On “Play” mode this button act as a tuner out switch.
when pressing it the guitar signal going from the input jack to the Tuner jack by that
keeping your tuner out of the audio chain.
Pressing the Tuner button also cancel all loops and by that it mutes the guitar and pedals
making your amp clean and quiet while tuning your guitar.
When you press it again to go out of the tuner mode you will get instantly to your last preset
Loops jacks - Each loop has send jack which will go to your pedal input jack and return jack which will be connected
to your output jack of your pedal. Loops 1-7 are mono , loop 8 has stereo return jack (use with Y cable) for stereo pedals.
S1-5 jacks - Those are your Relay switching jack for controlling amp channels , reverb and anything you want to switch
with a relay switch. all S jacks are truly isolated from each other and each have separate ground (GND not common).
CON Jack - This Jack represent S1-5 but HAS common grounds! you can use this jack to ask us for a custom cable for
your amplifier instead of using PL cables for the relay switches. *depend if the amplifier support common grounds*
Link Jack - This Jack uses RJ-45 connector to connect the SuperSwitcher to another SuperSwitcher for more features
which will be covered on the LINK CONNECTIONS section on the manual.
DC Jack - The Superswitcher uses a standard 9VDC - negative tip connection like most pedals on the market.
Audio Buffer - If you have a long cable or alot of pedals we recommand engeging the buffer
by keeping it UNPRESSED, you can adjust the level of the buffer by the small trimmer pot inside
the SuperSwitcher making it even as a booster.
To cancel the Buffer you need to press the switch ON.