Eccotemp i12 Use & Care Manual - page 24
22
Product Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locater: Eccotemp.com/locater
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
PLEASE NOTE: THIS MANUAL IS SUBJECT TO CHANGE AT ANYTIME, TO ENSURE THIS MANUAL IS UP TO DATE PLEASE VISIT OUR HELPDESK AT WWW.ECCOTEMP.COM
FOR ALL OF OUR PRODUCT MANUALS.
PLEASE NOTE: THIS MODEL IS FOR INDOOR PERMANENT INSTALLATIONS ONLY.
Installing the water heater
Installation Check List
A. Water Heater Location
Installed INDOORS.
• Close to area of mostly used outlet.
• Protected from freezing temperatures.
• Proper clearance from combustible surfaces observed.
• Sufficient fresh air supply for proper operation of water heater.
• Air supply free of corrosive elements and flammable vapors.
• Provisions made to protect area from water damage.
• Sufficient room to service heater.
• Combustible materials, such as clothing, cleaning materials, rags, etc. clear of the heater and vent piping.
• Water heater is properly attached to the wall.
B. Water Supply
• Water supply has sufficient pressure.
• Air purged from water heater and piping.
• Water connections tight and free of leaks
• Water filter is clean and in place.
• Materials used are as instructed in this manual.
• Water pipes are insulated.
C. Gas Supply
• Gas type matches rating plate.
• Gas supply pressure is sufficient for the water heater.
• Gas line equipped with shut-off valve, union and sediment trap.
• Approved pipe joint compound used.
• Commercial leak detector or soap and water solution used to check all connections and fittings for
possible gas leak.
• Gas Company inspected installation (if required).
D. Relief Valve
• Pressure Relief Valve properly installed and discharge line run to open drain
• Discharge line protected from freezing.
E . Electrical Wiring
• Voltage matches rating plate.
• Water heater is properly grounded .
• Wiring meets all local codes.
• GFCI Protection where required.