Beach house series (wall mount unit) 900-bhl- 2 / 1200-bhl- 3 / 1500-bhl- 4 owners manual page 2 introduction 3 specifications 4 5 standard system features installation layout 6-7 installation instructions 8-9 operation instructions 10 membrane cleaning procedure 11 maintenance timetable 12 troubles...
Introduction thank you for choosing an echo tec. Reverse osmosis desalination system. We trust that you will be completely satisfied with our product. The beach house series has been specially designed for small hotels, marinas and beach houses. The high power efficiency and low maintenance cost mak...
Specifications rated performance: echo tec: 500 – bhl – 1 min. 20 gallons – 75ltr. / hour 900 – bhl – 2 min. 38 gallons – 140ltr. / hour 1200 – bhl – 3 min. 50 gallons – 210ltr. / hour 1500 – bhl – 4 min. 60 gallons – 260ltr. / hour reverse osmosis performance varies with the feed water temperature ...
Standard system features 1) 1 seawater feed pump with 3/4” hose barb outlet 1 pvc sea strainer with 3/4” pvc pipe connection 2) 1 priming reservoir 2 3/4” pipe connections 3) 2 filter housings with bracket and 5 and 20 micron pre filter cartridges 1 storage/cleaning valve with 3/4” and 1/2” hose bar...
W a terlevel a t low tide beac hhouseseries installa tionla y out product max.2.7m/9f t. Max.9m/30f t. Reject nonreturnvalve seastrainer.
Installation instructions high pressure pump unit mount the high pressure pump unit in a cool and dry location, not higher than 30ft above low water level at a distance not further than 100ft / 30m. The electrical installation should only be done by a professional electrician. Check the correct volt...
Seawater feed pump and priming reservoir with the aid of the priming reservoir, the feed pump is able to prime the raw water up to a height of 9ft. Mount the feed pump in a dry location not higher than 9ft above low water level. Mount the priming reservoir with the outlet (lower connection) at the s...
System operation instructions the reverse osmosis membrane contains a preservative solution to prevent microbiological growth. If ingested, may cause irritation of the gastro-intestinal tract, colic, diarrhea, or other similar symptoms. Therefore, discard all the product water for at least thirty mi...
Fresh water flush procedure you should fresh water flush your watermaker after every use or infuse a biocide solution for long term storage. The fresh water flush prepares your watermaker for a shut down period of seven days maximum. You can repeat the flush procedure every seven days, to extend the...
Membrane cleaning procedure the membranes of the echo tec. Watermaker must be chemically cleaned when the product water output drops by 20% of the specified amount. The frequency of this occurring will vary greatly depending upon feed water. Fouling of the membranes will naturally occur during norma...
Maintenance timetable the following maintenance timetable is an estimate of the time intervals at which maintenance may be required only. This schedule must be adjusted to the regularity of usage, the condition of the intake water, the length of time the system is exposed to seawater and the total r...
High pressure pump system troubleshooting guide malfunction cause remedy the pressure worn packing seals replace seals drops broken valve spring replace spring fouled inlet strainer clean strainer fouled pre-filter(s) replace filter cartridge(s) cavitation check suction lines for restrictions water ...
∂ a ssembly - d isassembly o f t he p ump h ead 1.1-unscrewheadbolts. Tightening sequence of head bolts, for xt series and hpe series, for xr series and xl series. 1.2-removetheheadbyrotatingtheshaftandlevering betweenheadandbody. 1.3-forre-assembly:invertaboveinstructions,andkeep totorqueratesshown...
3.2-disassemblethecomponentsofthepistonguide, checkingthecondition,replaceifnecessary. 3.3-forre-assembly:invertoperation. R eplacing the pistons 4.1-removethehead(see∂),thenunscrewthepiston retainers. 4.2-slideofftheceramicpstions,checktheircondition, andreplaceifnecessary. 4.3-forre-asembly:invert...
Echo tec. Watermaker limited warranty echo marine ltd. Warrants to the original purchaser for a period of twelve (12) months from the date of shipment that the echo tec. Watermaker will perform according to specifications. Echo marine’s liability under this warranty shall be limited to repair or rep...
The echo tec. Membrane element is guaranteed to be cleanable for a minimum of one year from date of shipment, or commissioning of the system by echo marine ltd, provided that cleaning instructions are adhered to and foulant is acid soluble metal hydroxides and calcium carbonates or alkaline soluble ...
