Echelon SNOW18E Instruction Manual - Assembly
B
ASEMENT
B
RANDS
●
WWW
.B
ASEMENT
B
RANDS
.
COM
● CustomerService@BasementBrands.com ● 515-577-0977
5
1. Warning: read the Operator's Manual.
2. Cutting/dismemberment hazard, impeller - stop the motor before leaving the machine.
3. Thrown object hazard - keep bystanders a safe distance from the machine.
4. Fuel spill hazard - do not tip machine forward or backward.
5. To engage the auger, squeeze the control bar.
6. Release the control bar to disengage the auger.
WARNING: The motor is equipped with a protector that will disconnect power to the motor
temporarily if the snow thrower is overworked, and will automatically reset as the motor cools. If the
motor stops, release the control bar, disconnect the extension cord and allow the motor to cool 5
minutes before continuing operation.
WARNING: To prevent electric shock, use U.L. listed two conductor extension cords suitable for
outdoor use in cold. Do not use cords longer than 100 feet.
Assembly
1. Control Handle
6. Auger Assembly
2. Safety Switch
7. Chute Bolts
3. Chute Control Handle
8. Handle Bolts
4. Chute Cap
9. Upper Handle
5. Discharge Chute
10. Lower Handle
Attach Lower Handle to handle brackets
using 2 Handle Bolts and thumb nuts. Hand
tighten these bolts.
Attach Upper Handle to Lower Handle using
2 Handle Bolts and thumb nuts being careful
not to pinch the power cord. Hand tighten
these bolts.
Attach the Discharge Chute to the discharge
outlet using the 2 nuts and bolts provided.
The nuts should be on the outside of the
chute, not the inside. Chute should turn
freely.
Secure the power cord to the handle using
the cord retention clips.