1 e chelon ™ snow blower instruction manual sku: snow24 important: please read manual before assembly or use key technical parameters working width max. Throwing distance max output fuel tank cap. Startup mode net weight 24in. 36ft 5.5hp/4.1kw 3.6l manual 143lbs b asement b rands ● www .B asement b ...
2 hazard symbols wear eye protection wear ear protection wear gloves read the operator’s manual warning: hot surface! For operating and safety do not touch! Instructions. Warning description auger danger decal chute danger decal.
3 safe operation procedures danger: this machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on part of the operator can result in serious injury or death. This machine is capable of throwing objects an...
4 preparation 1. Thoroughly inspect the area where the machine is to be used. Remove all doormats, sleds, boards, wires and other foreign objects that could be tripped over or thrown by the auger/impeller. 2. Always wear safety glasses or eye shields to protect your eyes during operation and while p...
5 • never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. • do not operate machine while under the influence of alcohol or drugs. • exercise extreme caution when operating on or crossing gravel surfaces. Watch out for hidden ...
6 assembly 1. Mount the armrest: unscrew the nut and put four bores in order on the upper armrest. Insert the bolt and screw it with a nut. 2. Mount the connecting rod: pull out the pinchcock and pin bearing, then drill through a bore on the connecting rod with a pin bearing. Insert the pinchcock in...
7 operating controls warning: read, understand, and follow all instructions and warnings on the machine and in this manual before operating. Shift lever the shift lever is located between the lower handles. Place the shift lever into any of five positions to control the direction of travel and groun...
8 chute directional control the chute directional control is located on the panel of the snow blower. To change the direction in which snow is thrown, turn the control as follows: • crank it clockwise to discharge to the right. • crank counterclockwise to discharge to the left. A – discharge chute r...
9 before starting the engine do not start the engine until it has been filled with oil. Starting the engine without oil can cause serious damage to the machine. 1. Place the machine on a level floor. 2. Loosen the dipstick and read the oil level. The oil level shall be between the marks “high” and “...
10 to engage drive 1. With the throttle control in the fast (rabbit) position, move the shift lever into one of the four forward (f) positions or the reverse (r) positions. Select a speed appropriate for the conditions and a pace at which you are comfortable. Note: when selecting a drive speed, use ...
11 control wires the control wires must be adjusted after a long time of use, or when the belts are adjusted or replaced. 1. Lift the snow blower forward and rest in on the auger housing. 2. Push the wire through the spring so that the threaded part is exposed. 3. Hold the threaded part and adjust t...
12 lubrication warning: before lubricating, repairing, or inspecting the machine, disengage all of the controls and stop the engine. Wait until all moving parts have come to a complete stop. Chute directional control once a season, the joystick should be lubricated with petroleum jelly, linseed oil,...
13 drive belt replacement to remove and replace your snow bl ower’s auger belt, proceed as follows: 1. Remove the belt cover in the front of the engine by removing the two self- tapping screws. 2. Drain the gasoline from the snow blower or place a piece of plastic under the gas cap. 3. Carefully piv...
14 checking the spark plug check the spark plug annually, or after every 100 hours of use. 1. Clean the area around the spark plug. 2. Remove and inspect the spark plug. 3. Replace the spark plug if its porcelain is cracked or if its electrodes are pitted, burned or fouled with deposits. 4. Check th...
15 off-season storage preparing engine warning: never store the snow blower with fuel in its tank indoors, or in poorly ventilated areas where the fuel fumes may reach an open flame, spark or pilot light. Caution: alcohol blended fuels (called gasohol), ethanol or methanol can attract moisture which...
