Echo 99944200416 Installation Instructions Manual

INSTALL

METAL

SHIELD

If necessary, remove nylon head, plastic shield, and 38 mm upper plate.

1.

Loosely attach bracket (A) to shield (B) and attach to bottom of

gear housing (C) with screws and nuts provided.

2. Install nuts and lockwashers on screws where indicated and tighten

all hardware.

WARNING  

  DANGER

The type of Blade used MUST be matched to the type and size of

material cut.  An improper or dull blade can cause serious personal

injury.  Blades MUST be sharp.  Dull blades increase the chance of

kick-out and injury to yourself and bystanders.

INSTALL

OPTIONAL

BLADE

Metal or Plastic

1.

Install upper plate (D) with 20 mm diameter pilot on splined shaft.

Pilot must match blade center hole for proper fit.

2.

Place blade (E) over upper plate pilot and install the "lower  plate"

(F) and L.H. nut (G). Tri-Cut blade (H) is installed with glide cup (J).

3. Insert locking tool (K) through hole in upper plate and notch in

gear housing (C) to prevent splined shaft from turning, tighten nut

(G) and secure with a split pin (L).

IMPORTANT

Never reuse a cotter pin - install a new cotter pin each time a blade

is installed or replaced.

4.

Remove locking tool.

B

LADE

 C

ONVERSION

 K

IT

 I

NSTALLATION

I

NSTRUCTIONS

P/N 99944200416

For Models: SRM-230, 231, 260, 261   S/N: ALL

NOTE

The Barrier Bar is used to restrict rearward movement of the unit.  For heavy-duty or extended use, U-handles

should be used.  See your Echo dealer or Trimmer/Brush Cutter Safety Manual for details regarding U-Handles.  If

you have additional questions, contact your Echo Service Dealer, or call Echo directly at 1-800-673-1558.

WARNING  

  DANGER

Blade operation requires use of a harness (not included in kit) P/N C062000070 (USA) or P/N C062000060 (Canada)

to help restrict trimmer movement and maintain control of the unit if the blade snags, stalls or binds.  Blade operation

without a harness may result in serious personal injury.

X750005530

01/03

X7502233600

D

20

20

20

20

20

K

E

G

L

F

CONTENTS:

1, Upper Plate, 20 mm

1, Lower Plate

1, Harness Clamp w/spacer

1, Harness Ring

1, Barrier Bar

1, Metal shield

1, Bracket

3, 5mm x 15mm screws (shield mount)

2, 5mm x 8mm screws (bracket to shield)

4, 5mm nuts

4, 5mm lockwashers

1, 5 mm x 18 mm Bolt (Harness Clamp)

1, M10 x 1.25 L.H. Nut

B

A

C

D

E

F

G

L

K

H

J

NOTE

Use of a harness (not included) and this kit will allow use of metal or nylon grass/weed blades. All other metal blade

usage requires a "U" Handle Kit and restrictive harness.