Shaft hedge clipper attachment operator's manual model 99944200485 models used on: srm-2100sb srm-2400sb srm-210sb/211sb/225sb srm-260sb/261sb pas-2100 pas-2400 pas-2601 pas-210/211 pas-225/225vp/225vpb pas-230/231 pas-260/261 pas-265/266 x770001132 11/11 x7702091902 warning users of this equipment ...
2 copyright© 2011 by echo, incorporated all rights reserved. T able of c ontents introduction ................................................................2 - the operator's manual .......................................2 - the safety manual ..............................................2 safety ...
S haft h edge c lipper a ttachment o perator ' s m anual 3 warning refer to your pro attachment series or split boom operator's manual for correct engine fueling, starting and stop- ping instructions. Manual safety symbols and important information throughout this manual and on the product itself, y...
4 physical condition your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye protection wear eye protection that meets ansi z87.1 or ce re- q...
S haft h edge c lipper a ttachment o perator ' s m anual 5 repetitive stress injuries it is believed that overusing the muscles and tendons of the fingers, hands, arms and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities ...
6 equipment warning use this attachment with echo approved models only. Serious injury may result from the use of this attachment combined with a non approved echo product. Before operation a complete check of the unit must be performed; • check unit for loose/missing nuts, bolts and screws. Tighten...
S haft h edge c lipper a ttachment o perator ' s m anual 7 1 d escription locate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow the instructions on it. If it cannot be read, a new one can be ordered from your echo dealer. See parts ordering in...
8 parts required: pas or srm-sb power head w/shaft & coupling. 1. Set power head/shaft assembly on a level surface. 2. Pull locator pin (a) out, and turn counter-clockwise 1/4 turn to lock-out position. 3. Remove vinyl cap from attachment drive shaft. 4. Remove cardboard spacer, if necessary. 5. Car...
S haft h edge c lipper a ttachment o perator ' s m anual 9 front loop handle removal parts required: none note front loop handles/loop handles with barrier bars are not recom- mended for use with hedge clipper attachment. 1. Remove front handle assembly, barrier bar (if installed), and mounting hard...
10 1. Hold trimmer firmly and squeeze throttle trigger to accelerate engine. 2. Tilt trimmer so cutting teeth are angled slightly toward the hedge or shrub and proceed to cut. Warning never remove hands from unit when blades are moving. Warning the engine continues running even when the blades have ...
S haft h edge c lipper a ttachment o perator ' s m anual 11 lubrication blades level 1 parts required: 20w engine oil (lubrication), 50-50 mixture of kerosene and 20w oil (cleaning). Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades ...
12 drive shaft assembly level 1. Parts required: power blendx tm 8 oz. (p/n 91014) or lithium based grease. Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands 1. Remove gear h...
S haft h edge c lipper a ttachment o perator ' s m anual 13 1. Move stop switch to stop position. 2. Disconnect spark plug wire. 3. Slide blades to allow file clearance using slots (b) on bottom of blade. Do not pry against cutting edges. 4. File each edge carefully. Follow the original shape of the...
14 a blade adjustment level 2. 1. Move stop switch to stop position. 2. Disconnect spark plug wire. Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use long hex wrenches and sockets with extensions when tightening blade screws and blade locknuts to keep...
S haft h edge c lipper a ttachment o perator ' s m anual 15 s torage important always install blade cover when transporting or storing unit. 1. Clean and lubricate cutting blades and gear case. 2. Sharpen cutting blades as required. 3. Apply a light coating of clean 20w engine oil along entire lengt...
Dealer? Call 1-800-432-echo or www.Echo-usa.Com consumer product support 1-800-673-1558 8:30 - 4:30 mon - fri c.S.T. Echo, incorporated 400 o akwood r oad l ake z urich , il 60047-1564 www.Echo-usa.Com s07100001001/s07100999999 s ervicing i nformation parts / serial number genuine echo parts and ech...
