Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 1 pas articulating hedge clipper attach- ment operator's manual model 99944200595 for models: srm-2100sb srm-2400sb srm-210sb/211sb/225sb srm-260sb/261sb pas-2100 pas-2400 pas-2601 pas-210/211 pas-225/225vp/225vpb pas-230/231 pas-26...
2 copyright© 2013 by echo, incorporated all rights reserved. T able of c ontents introduction ....................................................................... 2 - the operator's manual .............................................. 2 - the safety manual ..........................................
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 3 warning refer to your pro attachment series or split boom operator's manual for correct engine fueling, starting and stop- ping instructions. Manual safety symbols and important information throughout this manual and on the produc...
4 warning users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Personal condition and safety equipment extended operation/extreme conditions it is believ...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 5 danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the manuals • provide all users of this equipment with the ope...
6 equipment • check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed. • never adjust blades when the engine is operating. • inspect hand guard for damage. Replace if damaged or missing. • check that the blade assembly is firmly attached and in safe operating condition....
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 7 1. Cutting blades - double reciprocating blades mounted to a blade support bar. Double sided blades, are ca- pable of cutting on either side of the blade. 2. Lower drive shaft assembly - includes the gear housing assembly, flexibl...
8 parts required: pas or srm-sb power head w/shaft & coupling. 1. Set power head/shaft assembly on a level surface. 2. Pull locator pin (a) out, and turn counter-clockwise 1/4 turn to lock-out position. 3. Remove vinyl cap from attachment drive shaft. 4. Remove cardboard spacer, if necessary. 5. Car...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 9 adjusting cutting angle warning never adjust cutting assembly with engine running. Warning hedge clipper blades are sharp. Always wear gloves when adjust- ing cutting assembly, otherwise serious injury may result. Warning do not s...
10 1. Hold trimmer firmly and squeeze throttle trigger to accelerate engine. 2. Tilt trimmer so cutting teeth are angled slightly toward the hedge or shrub and proceed to cut. Warning never remove hands from unit when blades are moving. Warning the engine continues running even when the blades have ...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 11 lubrication blades level 1 parts required: 20w engine oil (lubrication), 50-50 mixture of kerosene and 20w oil (cleaning). Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touch...
12 drive shaft assembly level 1 parts required: power blendx tm 14 oz. Cartridge or lithium-based grease. Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. 1. Brush loose de...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 13 6mm (.25 in.) radius a a 45 º important flat edge of washer (d) must be against drive shaft. C a d 1. Carefully remove locating screw (a) and loosen clamping screw (b). Remove the flex drive shaft assembly from the gear housing. ...
14 blade adjustment level 2. Warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use a socket and extension when adjust- ing blade bolts or blade locknuts in order to keep hands at a safe distance from sharp blades. 1. Move stop switch to stop position. 2. ...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 15 length ------------------------------------------------------- 1016 mm (40.0 in.) attachment width ----------------------------------------- 132 mm (5.2 in.) height ------------------------------------------------------- 127 mm (...
16 w arranty s tatements echo limited warranty statement for product sold in usa and canada beginning 01/01/2010 echo's responsibility echo incorporated’s limited warranty, provides to the original purchaser that this echo product is free from defects in material and workmanship. Under normal use an...
Pas a rticulating h edge c lipper a ttachment o perator ' s m anual 17 purchased repair parts, short blocks and accessories • 90-day residential, or non-income producing warranty • 30-day commercial, institutional, agricultural, industrial, income producing, or rental application warranty attention ...
18 notes.
19 notes.
Dealer? Call 1-800-432-echo or www.Echo-usa.Com consumer product support 1-800-673-1558 8:30 - 4:30 mon - fri c.S.T. Echo, incorporated 400 o akwood r oad l ake z urich , il 60047-1564 www.Echo-usa.Com s ervicing i nformation parts / serial number genuine echo parts and echo repower™ parts and assem...
