Echo 99944200840 Operator's Manual

Manual is about: PAS Trimmer Attachment

Summary of 99944200840

  • Page 1

    Pas trimmer attachment model 99944200840 operator's manual manuel d'utilisation bedienungsanleitung manuale istruzioni warning, see operator's manual lÌre soÌgneusement ce manuel avant toute utÌlÌsatÌon achtung! Bedienungsanleitung lesen attenzione, leggere il manuale istruzioni english italiano deu...

  • Page 2

    2 i ntroduction welcome to the echo family. This echo product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual and the safety manual you found in the same package. You will find both easy to use and full of helpful operating tips and s...

  • Page 3: Pas T

    3 pas t rimmer a ttachment o perator ' s m anual the circle with the slash symbol means whatever is shown within the circle is prohibited. S afety m anual s afety s ymbols & i mportant i nformation throughout this manual and on the product itself, you will find safety alerts and helpful, information...

  • Page 4

    4 symbol description/application symbol form/shape symbol description/application symbol form/shape keep bystanders away 15m the maximum speed of the cutting attachment shaft in r/min symbol description/application symbol form/shape symbol description/application symbol form/shape carefully read the...

  • Page 5: Pas T

    5 pas t rimmer a ttachment o perator ' s m anual extended operation / extreme conditions vibration and cold it is believed that a condition called raynaud’s phenomenon, which affects the fingers of certain individuals, may be brought about by exposure to vibration and cold. Exposure to vibration and...

  • Page 6

    6 safe operation warning danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Provide safety and operating instructions to all operators • provide all users of this equipment with the operat...

  • Page 7: Pas T

    7 pas t rimmer a ttachment o perator ' s m anual 1. Lower drive shaft assembly - includes the debris shield assembly, gear housing assembly, flexible drive cable, nylon cutter head and safety decals. 2. Plastic debris shield assembly - included in plastic bag (co-pack). Must be installed on unit bef...

  • Page 8

    8 a ssembly power head shaft / lower shaft assembly tools required: none parts required: pas or srm-sb power head w/shaft & coupling. 1. Set power head/shaft assembly on a level surface. 2. Pull locator pin (a) out, and turn counter-clockwise 1/4 turn to lock- out position. 3. Carefully fit attachme...

  • Page 9: Pas T

    9 pas t rimmer a ttachment o perator ' s m anual plastic shield installation (for nylon line operation) tools required: screwdriver. Parts required: plastic shield, shield plate, three (3) 5 mm x 15 mm screws. Note the plastic shield is for use with the nylon line head only. 1. Snap the shield on th...

  • Page 10

    10 o peration warning danger the cutting attachment should not rotate at idle. If attachment rotates, readjust carburetor according to "carburetor adjustment" instructions in this manual or see your echo dealer, otherwise serious personal injury may result. Note refer to the power head operator's ma...

  • Page 11: Pas T

    11 pas t rimmer a ttachment o perator ' s m anual lubrication level 1. Tools required: 8 mm open end wrench, screwdriver, clean rag parts required: lithium base grease. Gear housing 1. Clean all loose debris from gear box. 2. Remove plug (a) and check level of grease. 3. Add grease if necessary, do ...

  • Page 12

    12 nylon line replacement level 1. Parts required: echo 0.095 in. Nylon trimmer line 6 m (20 ft.) long. 1. Shut engine off. Lay unit on the ground with head assembly up. 2. Hold drum (a) and turn spool (b) cw (clockwise) until it stops. Pull spool from drum. Do not push in on spool when turning. 3. ...

  • Page 13: Pas T

    13 pas t rimmer a ttachment o perator ' s m anual 5. Stop when approximately 15-20 cm (6-8 in.) line (c) remains and place ends of line in notches (f) in spool (b). 6. Feed ends of line through housing eyelets (g) and place spool (b) over drive (h). Align pegs (i) on drive with notches in spool, and...

  • Page 14

    14 gb declaration “ce” of conformity the undersigned manufacturer: kioritz corporation 7-2 suehirocho 1-chome ohme ; tokyo 198-8711 japan declares that the hereunder specified new unit: pro attachment series brand : echo type : pas-2400 assembled by: echo, incorporated 400 oakwood road lake zurich, ...

  • Page 15: Pas T

    15 pas t rimmer a ttachment o perator ' s m anual notes.

  • Page 16

    K i o r i t z c o r p o r a t i o n 7-2 suehirocho 1-chome, ohme, tokyo, 198-8711, japan phone: 81-428-32-6118 fax: 81-428-32-6145 gb x770-000 151 x770227-1902 echo, incorporated 400 o akwood r oad l ake z urich , il 60047.