Echo CS-2511T Operator's Manual - Preparation For Use

10

CS-271T

   WARNING

Saw chain is sharp! Always wear gloves 

when handling assembly, otherwise serious 

personal injury may result.

KICK GUARD

®

 TO BAR  

INSTRUCTIONS

Tools Needed: Two 11 mm Wrenches.

For saws with Kick Guard

®

 P/N 2893201 and 

Symmetrical Low-Kick type (Double Guard) 

guide bars.

1. Install bolt (A) in 

rear

 hole (B) of Kick Guard

®

and through front hole (C) in guide bar.

2. 

IMPORTANT:

 Dimple (D) in Kick Guard

®

 must 

engage recess (E) in guide bar.

3. Tighten nut (F) and bolt (A) using 11 mm 

wrenches until snug. Make certain Kick Guard

®

is flush against guide bar.

4. Tighten nut (F) 1/8 additional turn.

5. Check to make certain Kick Guard

®

 is tight on 

guide bar.

GUIDE BAR AND SAW CHAIN  

INSTALLATION/REMOVAL

NOTICE

• Move the chain brake lever (Front hand guard) 

fully rearward to remove or install the clutch 

cover to chain saw.

1. Remove spark plug lead. (See page 26)

2. Remove the clutch cover nut and remove clutch 

cover.

3. Remove bar and saw chain if necessary. See 

“Maintenance and Care” section for guide bar/

saw chain maintenance procedures.

PREPARATION FOR USE

Bolt (A)

Dimple (D)

Recess (E)

Front hole (C)

Rear

 hole (B)

Nut (F)

Guide bar

Kick Guard

®

Clutch cover

Brake lever

(Front hand guard)

A nut